Frame Assembly Instructions
Package contents:
Remote Control
Retainer Bar(s) (Optional Hardware)
Base Legs
IMPORTANT UNPACKING
INSTRUCTIONS
To avoid damage to the power
base, always open the carton
while the power base is laying in
the FLAT position on the floor.
OPEN FLAT
STEP 8
If you are installing a headboard,
proceed to follow the Headboard
Bracket Assembly Guide on our
website. If not, place your mattress
on top of the power base. Power
base assembly is now complete.
STEP 7A
STEP 7B
If you have a retainer bar that
requires hardware, use the retainer
bolts and retainer bar plates to
fasten the Retainer Bar to the power
base.
If you have a tool free retainer bar,
Insert it into the two mount holes
located at the foot end of the power
base.
STEP 1
STEP 2
STEP 3
STEP 5
STEP 4
STEP 6
Assemble the power base legs.
Screw them in a clockwise direction
into the threaded holes in the frame.
Remove the zip ties securing the
excess cord from the motors of the
power base.
Carefully flip the power base over with
2 people, to the topside-up position.
Plug the power cord into a grounded
electrical outlet.
NOTE: An electrical surge
protection unit is recommended
(not included)
WARNING: POWER CORDS
MUST NOT INTERFERE
WITH ANY POWER BASE
MECHANISMS.
ATTENTION!
Improper handling
DO NOT
lean the power
base against the
installed legs to
flip it over.
NOTE: Use only a manual
screwdriver to install the retainer
bolts. DO NOT use a power
screwdriver to tighten the bolts.
WARNING: Remove the yellow
packaging bands from under the
frame before attempting to operate
the bed.
Remove the plastic packaging from
the power base. If there is a yellow
packaging band attached to the frame,
remove this as well.
NOTE: Be sure to use a
protective layer under the power
base to prevent damage to your
hard floors.
Carefully lift the power base unit
out of the shipping carton, keeping
the unit top side down. For safety
reasons, this should be performed
by 2 people. Be sure to lift the base
by the steel frame, securing the
head and foot sections of the base
so they do not move. Remove all
accessory components from the
undercarriage of the base.