4
English
STEERING ADJUSTMENT
If your kit “pulls” to one side when the
steering wheel is pointed straight,
move the steering trim lever the
opposite direction. Adjust as needed.
WHEEL CHANGE
Press the retainer to pull the wheel off.
When replacing the wheel, make sure
the hex engages properly in the rim.
BATTERY SAVER
After 5 minutes of no use, the controller
makes a tone and the LED blinks. After
an additional 5 minutes, it switches off.
The vehicle switches off approximately 3
minutes after the controller. To resume
driving, switch the controller and vehicle
off and on again.
CONNECTING THE VEHICLE
AND CONTROLLER
The connection of your vehicle and
controller is established at the factory.
If necessary to re-establish connection,
proceed as follows:
1. Turn off the car and controller.
2. Pull the controller trigger and hold it.
3. Turn the wheel all the way to the right
and hold it.
4. Turn on the controller and the LED
will begin to blink.
5. Hold the controller near the vehicle
and turn it on.
6. Once the controllers LED stops
blinking, the connection has been
made.
SERVICE
If your Revellutions Kit requires repairs or
replacement, DO NOT RETURN TO
RETAILER. Contact:
Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
(217) 398-0007
TROUBLESHOOTING
Problem:
The vehicle slows down and stops for no apparent reason.
Cause:
The vehicle battery is too weak.
Remedy:
Charge the battery.
Problem:
The vehicle cannot be controlled with the controller.
Cause:
The controller is switched off. The connection between the
controller and vehicle has been severed.
Remedy:
Move the controller switch to the “ON” position.
Re-establish connection between the vehicle and controller.
Problem:
Controller does not work.
Cause:
The controller is switched off. The batteries were not inserted
correctly. The batteries do not have enough power.
Remedy:
Repeat the switch-on process as described. Check that
the batteries are inserted correctly.
Problem:
The car does not move.
Cause:
The battery is too weak or depleted.
Remedy:
Charge the battery (see “Charging the Vehicle”).
RMXC3979 Chiller Mnl.indd 4
RMXC3979 Chiller Mnl.indd 4
4/18/2013 10:32:37 AM
4/18/2013 10:32:37 AM
Industry Canada Notice:
This device complies with Industry Canada
licence-exempt RSS standard(s).
1.Operation is subject to the following two
conditions:
(1) this device may not cause interference,
and
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
2.Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
