5
Flying mode
Battery icon
Remove the battery compartment cover from the back of the
transmitter. Install four AA batteries according to the “+” and
“–“ polarity markings imprinted into the battery compartment.
Replace the cover.
Also note the fl ying mode in the status display and make sure your transmitter is confi gured in the
desired mode.
Turn on the power/charge switch on the transmitter and observe the
battery icon in the status display. When the battery icon is blinking
this indicates that the batteries are too low and should be replaced.
Four squares inside the battery icon indicates that the batteries are
at full power.
With the transmitter on, remove the battery charge port cover
and fully install the rechargeable LiPo helicopter battery—note
that the exposed contact tabs face toward the front of the
transmitter. Make certain the green charge indicator light is
glowing, indicating that the battery is being charged.
Note:
The
power/charge switch must be “on” to charge the batteries.
Monitor the charge indicator light. Note when it goes out, indicating that charging is complete. Remove the battery. If not fl ying immediately, turn off the transmitter and set
the battery aside, noting all battery precautions written in the front of this instruction manual.
