3
Charging Procedure
Driving the Vehicle
Getting Started:
Operation:
1. Move the ESC switch to the “on” position.
2. Turn the transmitter on, by sliding the power switch to the
“on” position. The red LED should illuminate. If the LED does not
illuminate check that the batteries are installed correctly in the
transmitter and that the batteries are in good condition.
3. When you are fi nished driving, turn the truck off then the
transmitter. Make sure you always unplug the battery from the
truck once you are fi nished running. Failure to disconnect the
battery will cause a slow drain on the battery which could cause
damage to it.
NOTE: You must turn the vehicle on before the transmitter for
the transmitter and receiver to link properly.
ATTENTION
:
•
Allow the battery to cool off for 10-15 minutes before recharging.
•
Do not leave the battery unattended during the charging process.
• Charge times will vary depending on how much charge is left in the battery.
3. Disconnect the battery from the charger and
reconnect the battery to the speed control.
2. The charging process takes approximately 3.5
hours. For safety reasons, never charge the
battery for longer than 4 hours. While charging,
the red charger LED will be on. When the battery is
fi nished, the green charger LED will be on.
1. Switch off the car.
2. Carefully plug the charger into the USB port on
your computer or USB adapter.
3. Plug the vehicles lipo battery into the charger.
NOTE: You must plug the charger into the USB
port/adapter fi rst before plugging the battery
into the charger for the charger to perform
properly.
LED Charge
Indicator
• To slowly drive forward, pull the trigger slightly. To drive
faster, pull the trigger further.
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger.
• To turn, rotate the wheel to the left or right.
• Always move the controls slowly and with a gentle touch.
• When the vehicle battery becomes low, the vehicle will roll to a stop. The vehicle is equipped with a LVC (Low Voltage Cutoff) to protect the battery.
• Allow the battery to cool before recharging.
