RetroSound Techno Phonic, Руководство пользователя

Страница: 7 / 20

6
Copyright © 2017 Retro Manufacturing, LLC
Technophonic is designed to work within a range of 12 volts to 14.4
volts DC. Before connecting any wiring, use a multi-meter to test the
vehicle’s electrical system for adequate power supply. First, check the
voltage at the positive (+) battery terminal with the ignition in the off
position. The multi-meter should read no less than 12 volts. Next, check
voltage at the positive (+) battery terminal with the engine running. The
multi-meter should show a reading between 12 and 14.4 volts. If your
vehicle’s electrical system does not fall within these parameters, consult
an auto electrician before proceeding with the installation.
Technophonic utilizes a very efficient digital Class D design. For most
installations 8 to 10 gauge power and ground primary wire (not included)
are suitable. For longer runs, use thicker wire (Example: For installation
beneath the front seat, use 10 gauge wire. For installation in the trunk,
use 8 gauge wire).
Battery (+) Wire (Constant 12 volt)
A constant 12 volt Battery (+) Wire (not included) should be wired directly
to the vehicle’s positive (+) battery terminal using 8 to 10 gauge primary
wire. Start at the vehicle’s positive (+) battery terminal, and run the wire
back to the Battery (+) terminal on the side panel of the amplifier. Avoid
running the wire over engine components and heater cores. The use
of an in-line fuse (not included) is required at the positive (+) battery
terminal. Connect the fuse holder as close to the battery as possible
(within 6-8 inches of the positive (+) battery terminal). This fuse should be
60 amps. Leave the fuse out until final connections have been made.
Ground (-) Wire
Locate a metal area as close to the amplifier as possible (preferably the
floor pan or vehicle chassis). Use a wire brush or sandpaper to eliminate
any paint for a better ground connection. Secure the Ground Wire (not
included) to the vehicle using a bolt, star washer and nut (not included).
See diagram below for close-up of correct ground connection (connect
the other end to the amplifier’s Ground terminal).
POWER AND GROUND CONNECTIONS
NOTE: Remove any paint below the Ring Connector
Bolt
Ring Connector
Ground Wire
Star Washer