Retki R5603, Инструкция по эксплуатации

Страница: 47 / 65

13
6. Trouble Shooting
6.1 Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm environmental
conditions, set the Sensor Level to “High” and for cold weather use, set the sensor for “Low”.
2. Try to set your camera up in an area where no heat resources are in the camera’s field of view.
3. In some cases, set the camera near water will make the camera take images with no subject
in them. Try to aim the camera over ground.
4. Try to set camera on stable and immovable objects, i.e.: large trees.
5. At night, motion detector may detect beyond range of the IR illumination. Reduce distance
setting by adjusting sensor sensitivity.
6. Rising sun or sunset can trigger sensor. Camera must be reoriented.
7
. If person/animal moves quickly, it may move out of the camera’s field of view before photo
is taken. Move camera further back or redirect camera.
6.2 Camera Stops Taking Images or W on’t Take Images
1. Please make sure that the SD card is not full. If the card is full, camera will stop taking images.
Or user can turn on Cycle Recording to avoid such problem.
2. Check batteries to make sure that NI-MH or AA batteries left power is enough for camera to
work.
3. Make sure that the camera power switch is in the “On” position and not in the “Off” or “Test”
modes.
4. Please format the SD card with camera before using or when camera stops taking images.
6.3 Night Vision Flash Range D oesn’t Meet Expectation
1. Please install 6 or 12pcs AA batteries;
2. Please check to make sure that batteries are fully charged or left power is enough;
3. To ensure accuracy and quality of night time image, please mount camera to dark environment
without any obvious light sources;
4. A certain surroundings (like trees, walls, ground, etc.) within flash range can get you better
night time images; please do not aim camera to total open field where there is nothing within IR
flash range to reflect flash back; it
’ s like shinning a flashlight into sky in night, you just can ’ t see
anything; same does camera.
6.4 Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm e nvironmental
conditions, set the Sensor Level to “High” and for cold weather use, set the sensor for “Low”.
2. Try to set your camera up in an area where there is not a heat source in the camera’s line of
sight.
3. In some cases, set the camera near water will make the camera take images with no subject