2
“F4”: Set the beep mode. Enter 0, 1, 2 or 3 through the keypad, pick up the pager from the charging
base, and press “√” button to confirm within 3s. The pager will beep and flash after setting successfully.
If you set the reminder time is 0s, the pager will be alarm all the time.
0 stands for the beep close mode
1 stands for slow mode
2 stands for medium-speed mode
3 stands for fast mode
The default setting is medium-speed mode.
“F5”: Set the vibration mode. Enter 0 or 1 through the keypad, pick up the pager from the charging base,
and press “√” button to confirm within 3s. The pager will beep and flash after setting successfully.
0 stands for vibration close mode
1 stands for vibration on mode
NOTE: when you do all the settings are mentioned above, the pagers must be in the charging base and
connect the power. After all the setting completed, press the back button to exit.
4, Call Function
Input number and press CALL through the keypad, the corresponding pager will alarm to remind.
The default reminder mode is Vib Beep + Flash
The pager will stop reminding when get it back to the charging base or reach the set reminder time
If input wrong numbers, press the back button to delete and then re-enter the correct number.
Operating Instructions
1, Power On
Connect the power supply of the keyboard transmitter, the power indicator will be on and the screen
shows 3 numbers.
Put the pagers on charging base and connect the power source. In the charging state, the green light of
the pager is flashing.After the pager is fully charged, the green light is always on. The red light will flash
if the pager is not charged.
"Lo" will be displayed on the digital tube when the pager with a low battery. (This function only be ava-
ilable for the one model which built with digital tube)
The pagers could be powered on by putting back them to the charging base while it connects the power.
2, Power Off
Put the pagers on the charging base, press”0” and then CALL button to turn off all the pagers that in
the charging base. All the pagers in the charging base will be in the charging mode (there is no number
shows on the digital tube, only the green light is on). Then disconnect the charging case.
Don’t make the pagers charge or in standby mode for a long time when they are not used.
Otherwise it will reduce the battery performance.
3, Settings
Press the SETTING button to enter the setting mode, then press “+/-” buttons to select the function that
need to change, press “√” to confirm entry.
“F1” : Set the ID of the keyboard transmitter, it could be set to number 1 to 999, enter the number thro-
ugh keyboard, and then press “√” to confirm.
It is used when you need to use more than one keyboard transmitter to work with the same pager.
Or there is interference from other system.
Note: please do not modify the ID if none of the above occurs. All the pagers need to be repaired after
changing the ID.
“F2”: Pairing, set the ID of the coaster pager. Enter the number through the keyboard (1-999), pick up
the pager from the charging base, and press “√” button to confirm within 3s. The pager will beep and
flash after setting successfully.
“F3”: Set the pager reminder time. Enter the time from 1-200s through the keypad, pick up the pager
from the charging base, and press “√” button to confirm within 3s. The pager will beep and flash after
setting successfully. If you set the reminder time is 0s, the pager will be alarm all the time. The default
setting is 30s.
