Restwell Intalift Armchair Owner’s Handbook
Part Code Z50992 (Page 4 of 8)
•
Transformer Connection:
•
If the male / female plug connectors are not engaged correctly, they may disengage and power will be
lost. If this happens the emergency back up batteries in the transformer should be changed immediately,
as this will drain the power.
•
Plug the 3-pin plug into the Mains socket in the wall and switch on the power.
•
Operate the chair with nobody sat in it for a full rise and recline cycle. This is to ensure that the chair is
a suitable position and will not collide with any walls or furniture during operation.
4. Operating Instructions and Handset Use
•
To Operate the Rise
Only Chair (ILRLO):
•
Light
– the green light
will be on whilst any
button is being
pushed/activated.
•
Raise button
(A)
–
Press this button to raise
the armchair.
•
Recline button (B) –
Press this button to
lower the armchair to its
normal position
•
To Operate the Dual Action Chair
(ILR2) only:
•
Light
– the green light will be on whilst
any button is being pushed/activated.
•
Raise button
(A)
– Press this button once.
This will cause the chair to tilt forward and
lift up to allow easy access. Press the
button once again, and the chair will return
to its normal position.
•
Recline button (B) –
Press the button once
and the backrest will recline and the
footrest will elevate. Press the button once
again and the backrest will recline further.
From this position, press the button once to
raise the backrest and then press the button
once again and the chair will return to its
normal position.
A
B
•
Connect 2 PP3 (9-volt)
batteries (not supplied) into
the underside of the
transformer using the +/-
terminals (fig 1).
•
There is a small lead coming
out of the back of the
armchair near the floor with a
female socket (‘x’ in fig 2).
The 2 pronged male plug (‘y’
in fig 2) coming out of the
transformer must be plugged
into socket ‘x’.
•
‘x’ and ‘y’ should be pushed
together firmly (a positive
‘click’ will be felt / heard)
