
Page 5 of 10
Model No: 355 - 13
CALLUM FULL-OVER-FULL BUNK BED
BUNK BED END ASSEMBLY INSTRUCTIONS
STEP 1:
Attach the Top Side Rails (F) to the Bunk Bed
Ends (A) using Threaded Rods (1),
Curved Slotted Washers (2), Hex Nut (3) and
Wrench (5) that is provided.
Place threaded rods in the holes at top of Bunk Bed Ends (A). Align the top Side Rails (F) with the holes
and fasten tightly with curved slotted washers and hex nuts using the wrench provided.
Do not fully tighten!
Repeat the procedure with Bottom Side Rails (E).
Secure all metal brackets to the Back Duard Rails (C) using 8x19mm Short Screws (6) that are provided.
Tighten all bolts at this time.
NOTE: Each side rail needs 2 people to assembly, put the bunk bed end panel on a straight line, insert the side rail on end
panel at the same time and set up hardware to assembly but not fully tighten, set up another side rail & hardware,
then tighten them.