11
5.
Mount the base to the ceiling using the supplied fixing screws and plugs. Adjust
the tilt and panning positions of the camera lens as shown (Fig. 3).
6.
Refit the cover of the camera on to its base.
7.
If the position of the camera needs further adjusting after the system is powered
up, ensure the power is isolated from the cameras when removing the cover again
to prevent the risk of any shock.
Hea
vy Duty Cameras Installation
1.
Use the cameras main bracket to mark out the x 4 mounting holes and cable
connector’s entry hole on the chosen location of the wall (Fig. 4).
Drill 4 x 5mm holes for the
mounting bracket’s wall plugs and
1 x 20mm hole for the Camera’s
video and power plugs to pass
through the wall.
Note: It is r
ecommended to pass
the cable into the property as close
to the Camera as possible to reduce
the chances of any exposed cables
being tampered with. If you choose
to run the cable along the wall
Loosen Screw to Adjust
Panning Position
Adjust Tilt
Fig
. 3.
Mark out the single cable entry hole
in the central position in relation to the
4 x Camera Bracket Mounting Holes
4 x Camera Bracket
Mounting Holes
Fig. 4.