Setting Y
our Access Code
The Keypad is supplied with a pr
eset Access Code of:
However, for security reasons, it is essential that you
immediately change the Access Code to another four
digit number which only you and other users of the
system know (usually a number with a personal
significance is easier to remember).
To change the Access Code, press the following keys
in sequence:
IMPOR
TANT:
When using the Keypad the keys must
be pressed
fir
mly
and within five seconds of each
other.
Use your finger tip, not your finger nail to
operate the keys.
If you make a mistake, wait five
seconds and recommence programming from the
beginning of the sequence.
Ensur
e the
‘On Air
’
light flashes five times to confir
m
the setting has been accepted.
If the light does not
flash, wait five seconds and re-enter the programming
sequence from the beginning.
Operation
T
ake the system out of Test/Service mode (Refer to
your Installation and Operating Manual for details).
To Arm your system (only with a 15 second Entry/Exit
Delay), enter your Access Code followed by .
The On-Air light will flash once; your system will
commence arming and you should leave the premises
before the Exit Delay time expires, or a full alarm
condition will occur.
On returning to the premises; immediately go to the
Keypad and enter your Access Code followed by
.
Note: The Keypad may be used in conjunction with a
hand-held Remote Control, so that the system can be
armed via the Keypad, and disarmed via the Remote
Control before re-entering the premises. However,
arming via the Remote Control and disarming at the
Keypad may not be possible if the Remote Control
does not have an Entry/Exit Delay arm facility.
Personal Attack Alar
m
A full alar
m condition can be initiated from the keypad
in the event of threat or danger by pressing and
holding the and buttons together for two
seconds. To silence the alarm enter your Access
Code followed by .
Low Batter
y Indication and
Battery Changing
If the On-Air light flashes rapidly when the Keypad
is operated, this indicates that the Keypad battery
needs replacing.
To change the Keypad battery, set the system to
Test/Service mode and undo and remove the back-
plate securing screw at the bottom of the Keypad.
Disconnect and remove the battery and connect a
new 9 Volt PP3 Alkaline battery.
IMPOR
TANT:
The Keypad will r
etain the Access
Code setting for approximately 15 seconds whilst the
battery is removed and replaced. If the battery is left
disconnected for longer, or has run completey flat
the Keypad will revert to the preset
Access Code and will need to be reprogrammed as
detailed above, after replacing the battery.
Remember to take your system out of Test/Service
mode after refitting the Keypad.
1
3
2
4
1
3
2
4
OFF
OFF
OFF
ON
ON
OR Current Access Code
New Access Code
ON
ON
1
3
2
4
?
?
?
?
ON
Installation and Operating Instructions - continued
W
A_08.04
CA2000KP
W
ireless Alarms.
1
7 Church Road, Great Bookham, Surrey KT23 3PG
Telephone: 01372 450960 E-mail: [email protected] www.wireless-alarms.net
0359
RADIO DEVICES FOR USE IN THE UK
HELPLINE
If you need help, just dial for
expert technical support
0
1372 450960
(Lines open 9.00am to 6.00pm, Monday to Friday).