Hand Held Edge Deletion Tool Manual ● Resources Unlimited Company, Inc. ● Rev. 2.11 ● Page 9
4. Maintenance
4.1 Regular Maintenance Notes
1. When tightening U Bracket, DO NOT OVERTIGHTEN as this may cause damage to the
air tool.
2. REPLACE white plastic guide if it becomes deeply grooved by contact with glass edge.
Failure to maintain guide will result in incorrect edge deletion depth.
3. Make sure that Black EDHH Shield and EDHH Alum Guide are PROPERLY ALIGNED at
a 90 degree angle to the air tool when reassembling after disassembly.
4. Clean and check aluminum EDHH Shield guide regularly for wear. Replace if damaged.
5. OIL EDHH GRINDER DAILY as specified on the tool.
4.2 Dressing the Edge Deletion Wheel
A wheel should be dressed or cleaned when the edge has a glazed appearance.
Be sure to
wear safety glasses with side shields when performing this operation.
1. Adjust the arbor so that the wheel is far enough from the white plastic guide so that a
regular wire brush can be placed against the entire edge of the wheel but still under the
guard.
