Quick guide
– GETTING STARTED
WIRELESS CONNECTIVITY
resound.com
GETTING STARTED
(Charge the Multi Mic before use)
1. Turn on the Multi Mic: Push and
hold
the power button
A
on
the top of the Multi Mic until status light
B
blinks green.
2.
Connect your hearing aids
to the Multi Mic: Push and
hold
the
program button/toggle button
on your hearing aids
until you
hear a melody.
Check the connection by blowing or tapping on the Multi Mic.
This sound should be audible in your hearing aids. If this is not
the case, see the troubleshooting guide on the reverse page.
3. To exit the Multi Mic streaming program: Push the program
button/toggle button on your hearing aids. You hearing aids will
return to the most recent hearing aid program indicated by one
or more beeps.
4. Turn off the Multi Mic: Push and
hold
the power button until the
status light turns red and then off.
B
STATUS LIGHT
• Will blink green every other second when
the Multi Mic is turned on and charged.
• Will blink orange every second when there
is less than 30 minutes battery left.
C
VOLUME CONTROL
Use the volume buttons on the side
of the Multi Mic to adjust the
volume. Press ‘+’ to increase
volume and ‘-’ to decrease volume.
(Mute/Volume light
E
will blink
each time volume is adjusted)
Mute
Mute/Volume light
USB charger
Volume control
Power button
Status light
A
D
E
C
F
B
F
CHARGING
• Insert the charger in the micro
USB plug on the side of Multi
Mic to charge.
• Status light indications when
charging:
Power/Charging
Charging
Fully charged
Powered Off
Powered On
D
MUTE
To mute the Multi Mic press the mute button.
Now the mute/volume status light
E
will blink
orange every second. To unmute press mute
button again, mute/volume light will stop
blinking.
Mode button
Modes and
Mode light
SWITCHING MODE:
Modes:
• Microphone
• T-coil
• Line in
• FM (audio system)
1. Push the mode button on the back of
the Multi Mic. The mode light next to the
current mode will light up green.
2. Push mode button again within 3 seconds
to switch mode.
• When connecting either a mini-jack cable
or an FM receiver to the Multi Mic, the
corresponding mode will automatically
be selected if the unit is turned on. These
modes (Line-in and FM) can only be
selected if either a mini-jack cable or an FM
receiver is connected to them.
• You can switch out of these modes even
when the FM or line in are connected by
pressing mode button until the desired
mode is reached.
400585011-US-15.12-Rev.A.indd 1
03-02-2016 11:49:54
