Lab
RAM II Jacketed Vessel Users’ Manual
REPLACEMENT PARTS
Resodyn Acoustic Mixers, Inc.
7
010320
4
General Notes
For use with the LabRAM ll mixer, the Jacketed Vessel assembly consists of:
•
Jacket fixture that attaches to the LabRAM II Resonator Plate
•
Removable mixing vessel
•
Fixture lid with RTD and vacuum ports.
The system bolts into place, replacing the vessel holder on the LabRAM ll and features
ports for an RTD temperature probe port and two vacuum lines. The system’s metallic
surfaces are 316 stainless steel.
4.1
System Description
The LabRAM II Jacketed Vessel accessory consists of the following:
•
One 316 stainless steel (SS) Jacketed Vessel fixture with 1/8” female NPT
connections for heating/cooling transfer fluid inlet and outlet
•
One 500 ml/16 oz. payload capacity 316 stainless steel mixing vessel
•
One 316 stainless steel fixture lid with fittings for vacuum lines and RTD probe
•
One stainless steel Sanitary Quick-Clamp
•
Four Viton O-rings (two large and two small), required for face seal between
Jacketed Vessel fixture and removable mixing vessel, and between the removable
mixing vessel and Jacket fixture lid.
For O-rings of special materials, please call 406-497-5333
•
6” long 316 SS sheathed Resistance Temperature Detector (RTD)
•
PTFE RTD sleeve, ½” PTFE front and rear ferrules, and compression nut
•
RTD Cable
•
Vacuum lines connecting LabRAM II vacuum ports to Jacketed Vessel fixture Lid
•
Four tube plugs (for operation without vacuum, includes two extra)
•
Four bolts with washers for anchoring the Jacketed Vessel fixture to the LabRAM II
platform
•
Two braided SS flex hoses for Jacketed Vessel heating/cooling transfer fluid
service loop connections to back panel of LabRAM II
A cutaway of the LabRAM II Jacketed Vessel system including significant components is
shown in Figure 4-1.
Note: A compatible LabRAM II mixer and heat/cooling transfer fluid supply system are not
included in the Jacketed Vessel components, but are required for its use. Refer to the
user manual for your heater/chiller system for installation and operating instructions. If you
need a heat transfer supply system, please contact Resodyn at 406-497-5333.
