MAT SET UP
Each Resilite mat is custom manufactured.
Resilite LiteWeight Mats are manufactured in
multiple sections that
require the sections
to be properly taped together prior to use.
STEP 1:
Begin by placing each mat section into position on
the floor. Unroll Section #1 (L1), L2 and so forth, until all mat
sections have been unrolled.
NOTE:
Once each mat section
has been placed on its side,
remove strap(s) from around
the mat.
STEP 2:
Once the mat
sections have been
unrolled, you can begin
to align each section by
sliding them into place.
This works best when
one person is positioned
at each end of the mat
section. Each section
must be lined up together so that the markings and lines
properly align.
PREPARING YOUR MAT FOR FIRST USE
4
TEMPERATURE
NOTE:
Please see page two (2) for an important
safety warning regarding temperature before beginning to unroll
your mat.
ALIGNING YOUR MAT
In order to align and match-up the lines of your mat,
start by straightening each mat section. Make sure each
section is pushed close or “butted” up to the section next
to it so there is no gap between sections.
Align the mat so that the
bottom
of the large circle lines match.
It may be necessary to shift
the far end of the mat either
to the right or to the left.
Then push or pull section(s) until
the circle lines match.
NOTE:
Once you have the mat sections aligned, use mat tape to
securely fasten each section together.
MAT ALIGNMENT:
It may be necessary to shift each mat section
to properly align the mat.
WARNING
MAT PROTECTION MAY VARY ACCORDING TO
ROOM TEMPERATURE.
IMPORTANT:
Mat shock-absorbency performs best when room
temperature is between 68° F and 72° F. If the room temperature
exceeds 78° F, additional padding may be necessary to meet the
minimum shock-absorbency standards of ASTM F355. For more
information on ASTM Standards, please visit www.astm.org.
MAT SIZE:
All foam mats are subject to expansion
and contraction due to environmental
and physical conditions.
Because of the physical properties of the foam used,
LiteWeight Mats will not shrink,
however,
they are
subject to minimal size variances of less than 1%.
Resilite guarantees that our LiteWeight Mats will be
manufactured within a +/-1% tolerance of the overall
mat size ordered.
MAT SECTIONS SHOULD ALWAYS
BE PROPERLY TAPED TOGETHER
PRIOR TO USE.
L1 L2 L3 L4R R5 R6 R7
L1
L2
L3
L4R
R5
R6
R7
