®
WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
RL-BV240A / RL-BV250B
AV Distribution Range
‘linx-AV’ Quad IR Component Video/Audio Balun Transmitter (1:4)
IR Component Video/Audio Balun Receiver
www.resi-linx.com
ABN: 99 091 281 524
Vcomm Pty Ltd
* Sold separately
A
B
C
D E
K
F
G
I
RL-BV250B
J
A RCA Component Video inputs
B Loop Through RCA Comp. Video outputs
C RCA Digital Audio input
and Loop Through output
D IR Emitter output
E IR / Power LED’s
F 12V DC Power input
G Analogue Audio input
H RCA Component Video output
I RCA Digital Audio output
J IR Target input
K Analogue Audio output
H
RL-BV240A
IR
Cable Requirements
4 pair twisted cable
Hardware Connection
1. Ensure all power to equipment is switched off prior to
installation.
RL-BV240A
2. Connect RCA cables from Component source to terminals
A of Transmitter.
3. Connect RCA cable from Digital Audio ouput on
Component source to Digital Audio input C of transmitter
4. Connect audio cable from Analogue Audio output on
Component source to Analogue Audio input G on
transmitter (if required)
5. Connect a second RCA cable from loop through terminals
B of Transmitter to the Component input of the local AV
device (TV, etc).
6. Connect RL-IR700/800* IR emitter to output D of
Transmitter. Place the other end within 25cm of the
IR receiver on the Component source (depending on
environmental conditions).
7. Connect 2 x RJ45 sockets of Transmitter (OUTPUT
I
A
and OUTPUT
II
A) to corresponding INPUT
I
and
INPUT
II
Receiver in zone A via 4 pair twisted cable. Repeat for
zones B, C and D. (eg. OUTPUT
I
B and
II
B to zone B
INPUT
I
and
II)
RL-BV250B
8. Connect Component Video RCA lead (red, green,
blue) from RCA Video output H of Receiver to the
corresponding input on the component device (TV, etc).
9. Connect Digital Audio RCA lead (orange) from RCA
Digital Audio output I of Receiver to the corresponding
input on the component device (TV, etc).
10. Connect Analogue Audio lead (green) from Analogue
Audio output K of Receiver to corresponding input of
the component device (TV, etc).
11. Connect RL-BV500* IR target to input J of Receiver.
Flat target can be easily mounted (either directly using
adhesive backing, or by using RL-ACC150* Target
Mount) to the desired location, anywhere within the line
of sight of remote controls.
12. Repeat steps 8 - 11 for connection of zones B, C and D.
13. Connect supplied 12V DC switch mode power pack to
power input F on Transmitter.
14. Once installation is complete, switch on power to
all equipment. Check green PWR LED E on
Transmitter is illuminated.
INSTALLATION MANUAL
OUTPUT
II
OUTPUT
I
Transmitter
Receiver
RJ45 Output
RJ45 Input
