PCI Express Gigabit Ethernet Adapter
8 User’s Manual
Step 3:
Connect the network cable to the connector on the PCI Express Fiber
Gigabit Ethernet Adapter. This network cable consists of two individual
cables: one for ‘transmission (TX)’, and the other for ‘reception (RX)’.
Step 4:
Connect the other end of the network cable to a 1000BASE-SX/LX
switch.
<Note>
i.
Insert the cable that is connected to the transmit (TX) connector on the PCI Express
Fiber Gigabit Ethernet Adapter into the receive (RX) connector on the network switch.
ii.
Insert the cable that is connected to the receive (RX) connector on the PCI Express
Fiber Gigabit Ethernet Adapter into the transmit (TX) connector on the network switch.
Step 5:
When the cable is properly connected to two end devices, turn on the
power to the PC.
Step 6:
Check the LNK (Link) LED. The LED will come on when the PCI
Express Fiber Gigabit Ethernet Adapter is receiving a good link signal
from the connected device, a switch.
Step 7:
Proceed to next section for installing the network driver.