(2)
Technical Specification
Topology
: Star
Connector
: RJ-45
Standard
: IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3ab 1000Base-T
Transmission Rate
: 10Mbps or 20 Mbps
100Mbps or 200Mbps
1000Mbps or 2000Mbps
Hardware Required
: IBM compatible PC with available PCI
Slot (PCI2.1/2.2), 33MHz, 32bit
IRQ Line
: Assigned by system
I/O Address
: Assigned by system
Drivers
: NDIS 4/5 for Windows 95/98/Me/NT/2000
Linux, Netware 5.x, Free BSD
LEDs
: 1000Mbps
LNK/ACT
Temperature
: 0
℃
to 55
℃
(Operating)
Humidity
: 10% to 90% (Non-condensing)
Certification
: FCC Class A,CE Mark
Dimension
: 120 x 52 mm.
Power consumption
: 5W (Max)
3.0
Installation
(1)
Hardware Installation
To insert the network adapter into your PC, follow the steps bellow:
1.
Turn off the computer and remove its cover.
2.
Insert the adapter into a PCI slot.
3.
Lock this adapter to the rear of the computer and put back the computer cover.
4.
Connect the adapter to network using twisted-pair cable.
(2)
Driver Installation
Use the drivers supplied by the diskette included in this product.
4.0
Trouble- shooting
If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper
cable is connected to the adapter port and the hub/switch complies with the adapter specification, such as
10Mbps 10Base-T, 100Mbps 100Base-TX and 1000Mbps 1000Base-T, then check the LED.
The adapter provides two LEDs to indicate network status.
1000
When the light is ON, it indicates that the adapter works at 1000Mbps.
LNK/ACT
The LED indicates if the UTP has been LINK ok or not. When the light is OFF, it indicates that the
UTP port has not been connected or LINK not ok. When the light is ON, it indicates that the UTP port
LINK ok. When the light is BLINKING, it indicates that is traffic flow on the network which the
adapter is connected to.
