Wireless Acccess Point Router
3.2.1 PPPoE Connection for WAN
If your ISP uses PPPoE (Point-to-Point Over Ethernet) to establish communications
with end-users, you will receive information such as
User Name
and
Password
from
them. To set up a PPPoE connection for WAN, follow the instructions as shown in
Figure 3-4
Cable/DSL Setup Menu Screen
and Figure 3-5
Cable/DSL Setup Menu with
“No” Option Screen
. Then, you need to configure the following values to make your
router work. (See Figure 3-6
PPPoE Menu Screen
)
-
User Name
and
Password
Fill in the entries with the information you get from your ISP.
-
Service Name
If your ISP provides this info, please type it into the field.
-
Connect
on Demand
If you have been disconnected due to inactivity,
Connect on Demand
will enable you
to establish a connection again between your Router and ISP.
-
Max Idle Time
The Max Idle time is the amount of time you would like to pass before the Router
drops your Internet connection due to inactivity. Enter zero (0) in the field to remain
Internet connection on at all time. The idle time ranges from 0 to 60 minutes.
Figure 3-4
Cable/DSL Setup Menu Screen
16
Содержание 03075 RP-WR1134
Страница 1: ...03075 RP WR1134 USER S MANUAL...
