RENPHO RP-AP001S, Руководство пользователя

Страница: 39 / 42

Note
:
Press button or simply not press anything for 60 seconds
and the appliance will exit the Filter replacement force mode.
1) Power plugged and turn off the appliance, press and hold for 5 seconds and
the filters light will flash.
2) Press button repeatedly to choose the appropriate filter. The chosen filter
light will stop flashing. Press and hold button for 3 seconds and the filter
light turn off and the complete the reset.
This chapter summaries the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the informa-
tion below, contact us directly via e-mail at: support@renpho.com or phone:
1(844)417-0149.
Troubleshooting
Problem Possible cause Possible solution
Back cover cannot be fastened
in place
The appliance
doesn't work
Power plug is not connected to a
power supply.
Unplug and then plug the power in
again.
Remove the back cover and re-install it
The machine does not turn on
Plug in the power and turn on the
machine again.
Outlet airflow
significantly
reduced
Filter's plastic packaging hasn’t
been removed
Air quality is good, and the Auto
mode has been activated.
Filter's plastic packaging should be
removed before use.
To exit the Auto mode by pressing the speed
button; the appliance will revert to manual
control and the Auto mode light will turn off.
Night mode automatically starts and
the LED indicator turns off.
Meanwhile the fan speed and noise
is also reduced.
Manually select your preferred fan
speed.
The Pre-filter is dirty.
The filters haven't be replaced
Clean the Pre-filter.
Replace the filter(s).
Not enough clearance and space
for ventilation
Make sure the rear and sides of the
device has 40cm of clearance.
Fan speed can't
adjust automatically
Air quality sensor becomes damp or
the indoor temperature is too high,
which causes condensation to form
on sensor surface.
Keep the air quality sensor clean and
dry.
Use the air purifier in a room with
applicable area.
The room coverage exceeds
applicable area.
Poor performance or
not enough purifica-
tion capacity
Too noisy
Air quality indicator
color unchanged
After replacing filter,
the filter replacement
indicator still flashing
Filter's lifetime not reset correctly
Indoor air ventilation is poor.
The air quality sensor is dirty.
Filter's plastic packaging hasn’t
been removed
Air inlet or outlet of the machine is
blocked.
Remove blocking object.
Filter's plastic packaging should be
removed before use.
Clean the air quality senor.
Open the window and improve air
ventilation.
Check the manual instructions for
"Reset Filter's lifetime".
37