Owner‘s Manual Hand Crimping Tool PEW15
Rev.: 2017-08-14
6 / 6
8. Warranty
RENNSTEIG- Products are thoroughly checked by the Quality Control Department. The general terms and
conditions apply.
The adjsutment of the crimping force is done as follows:
1. Open crimping tool.
2. Remove hex screws
(4.1)
with an Allen wrench 2,0mm.
3. Turn the adjustment disk
(4.2)
with a screw driver
counterclockwise
: a higher crimping force and
therefore a lower crimping height is achieved.
4. Turn the adjustment disk
(4.2)
with a screw driver
clockwise
: a lower crimping force and therefore a
higher crimping height is achieved.
5. Secure hex screw
(4.1)
with an Allen wrench 2,0mm.
9. Maintenance and Service
The Hand Crimping Tool must be in clean and proper working conditions prior to usage. Crimping residue
needs to be removed. The joints need to be oiled regularly with light machine oil and need to be protected
from dirt. Please ensure that all screws are secured by retaining rings. The tightness of the hex screws of the
adjustment disk needs to be checked. All repairs are carried out by the tool manufacturer only.
Please ensure that the hex screws are tightened securely prior to using the tool.
Attention
4.1
Hex Screw 2,0mm
4.2
Adjustment Disk
Fig. 4