31
b) Connecting the Speaker Outputs
Connection to the speakers must be two-wire each. Insulate all connection points. Make sure
that the cables are not damaged by sharp edges. Only use speakers with sufficient load capaci-
ty (see „Technical Data“).
Connect the speakers directly with the amplifier. Do not use any headphones or junction boxes.
If in doubt, contact a specialist.
Make sure that all speakers have the correct polarity, i.e. the plus and minus signs must
match.
This amplifier has been designed for a speaker impedance of 6 to 8 Ohm on each channel. Never
use any speakers with a lower impedance. Only connect one speaker to each output.
Connect the speaker pair to the terminals marked SPEAKERS.
• Connect the (+) pole of the left speaker to the red speaker clamp designated „LEFT+“.
• Connect the (-) pole of the left speaker to the black speaker clamp designated „LEFT-“.
• Connect the (+) pole of the right speaker to the red speaker clamp designated „RIGHT+“.
• Connect the (-) pole of the right speaker to the black speaker clamp designated „RIGHT-“.
_
L
RI G H T
L E F T
_
SP E A K E RS 6 ~ 8
L
R
