Renfert Klettfix MT2, Инструкция по эксплуатации

Страница: 2 / 10

MT2 Trimmer
Nr. 1801-0000
ENGLISH
1. Introduction
We are pleased with your decision to purchase the
MT2
- Trimmer which sets new standards with respect
to function, performance, safety, and styling.
DSS Disc Stop System:
This trimmer is equipped with a maintenance-free
electronic motor brake. After the unit is switched off or
if the front cover is opened, the trimmer disc is stopped
within 5 seconds. The resulting buzzing sound
emanating from the motor area is perfectly normal.
Please read the following operating
instructions carefully and observe all the
information they contain in order to
ensure long and trouble-free service.
2. Application Area
The
MT2
is a wet trimmer used for grinding plaster or
acrylic models for dental technology applications.
2.1 Ambient Conditions
(in accordance with DIN EN 61010-1)
The unit may only be operated:
• indoors;
• up to an altitude of 2,000 m [6,500 ft] above sea
level;
• at an ambient temperature range of 5 - 40ºC [41 -
104ºF] *);
• at a maximum relative humidity of 80% at 31ºC
[87.8ºF], dropping linearly to 50% relative humidity
at 40ºC [104ºF] *);
• with a mains power supply whose voltage
fluctuations do not exceed 10% of the rated value;
• under contamination level 2 conditions;
• under over-voltage category II conditions.
*) Between 5 - 30ºC [41 - 86ºF] the unit can be operated at a
relative humidity of up to 80%. At temperatures between 31 -
40ºC [87.8 - 104ºF] the humidity must decrease proportionally in
order to ensure proper operability (e.g., at 35ºC [95ºF] = 65%
relative humidity, at 40ºC [104ºF] = 50% relative humidity). The
unit may not be operated at temperatures above 40ºC [104ºF].
3. Hazard Information
3.1 Employed Symbols
The following symbols are used in these instructions
and on the unit:
Danger
This indicates an imminent risk of injury.
Electrical hazard
There is a risk of electrical shock.
Attention
Failure to observe the associated
information can result in damage to the
unit.
Note
The operating instructions contain useful
information to make handling easier.
Wear eye protection.
For indoor use only.
Before opening the unit, disconnect it
from the mains power supply by pulling
the wall plug.
Note the operating instructions.
3.2 Hazard Information
During trimming, please observe the accident
prevention regulations of the relevant professional
association as well as the following safety information:
• The MT2 is an electrical device with inherent
hazard potential. This device may only be
installed and operated by authorized
specialists after examination of compliance
with locally applicable standards.
• The unit may only be connected to a properly
grounded power supply.
• Prior to commissioning, compare the voltage
information on the nameplate with the
specifications of the local mains power
network.
• Never touch the trimmer disc while the unit is
connected to the mains power supply. Serious
injury could result should the unit accidentally
start!
• Never wear loose clothing when working with