Renfert Basic quattro 2954-0005, Инструкция по эксплуатации

Страница: 6 / 12

- 16 - EN
• Any residue of abrasive material on
the gasket may lead to leakage and
early wear of the gasket. After filling
up clean the thread and the gasket
and close the lid properly.
• Solvents and tensides can create
micro-cracking in the plastic (dan-
ger of explosion!). Clean the tank
and the lid only with a dry cloth. Do
not write or stick something on the
tanks.
• Check the tanks and the lids regu-
larly on damages and replace them
in case of doubt.
• Check the tank cover for correct
seating prior to beginning operation.
Covers that are not securely closed
can suddenly be blown off as the
tank pressure increases. The result-
ing flying parts and abrasive repre-
sent a serious hazard.
• Never operate the blasting units
without suitable dust extraction and
appropriate protective gear, as this
could result in health hazards. The
type of dust extraction should be se-
lected on the basis of the dust being
generated. Follow here absolutely
EN 60335-2-69 appendix AA or ask
the appropriate authorities.
• Improper use can result in the risk of
eye or skin injuries.
• Never direct the blasting material
towards eyes or unprotected areas
of skin!
• Never work with the view screen
open!
Caution: Failure to wear proper
eye protection can result in eye
injury due to particles sus-
pended in the air. Always wear
proper eye protection to protect
your vision!
• Do not employ the foot switch when
only the compressed air supply hose
is connected. The loose hose could
wrap around itself and cause serious
injury.
• Unplug the unit from the wall outlet
before changing the fluorescent tube.
• Do not squeeze or bend the fluores-
cent tube body when replacing the
tube (breakage hazard). Always wear
gloves or use a towel to protect your
hands against possible glass
splinters.
• Inspect power cords before begin-
ning operation. The unit may not be
operated if the power cord is
damaged.
3.3 Liability Exclusion
Renfert GmbH shall be absolved from
all claims for damages or warranty if:
• The product is employed for any pur-
poses other than those cited in the
operating instructions;
• The product is altered in any way oth-
er than those alterations described in
the operating instructions;
• The product is repaired by other than
an authorized facility or if any but
Renfert OEM parts are employed;
• The product continues to be em-
ployed, despite obvious safety faults.
4. Installation /
Commissioning
4.1 Setting up and Connecting
the Unit
1. Inspect the tank for proper installation
(Fig. 1).
2. Check the voltage information on the
nameplate.
3. The unit is operational with two tanks.
To connect additional tanks, please
refer to Installation
Instructions, No. 21-9498.
4. Remove the foot switch from its ship-
ping location in the blasting chamber.
5. Connect the foot switch to the sand-
blasting unit (red + yellow). Make sure
to both pneumatic hoses are fully
inserted up to their stops (Fig. 2).