LE6XRT ERV
RENEWAIRE.COM
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
1.800.627.4499
2
IMPORTANT SAFETY INFORMATION
WARNING
ARC FLASH AND ELECTRIC SHOCK HAZARD
Arc flash and electric shock hazard. Disconnect all electric
power supplies, verify with a voltmeter that electric power is off
and wear protective equipment per NFPA 70E before working
within electric control enclosure. Failure to comply can cause
serious injury or death.
Customer must provide earth ground to unit, per NEC, CEC and
local codes, as applicable.
Before proceeding with installation, read all instructions,
verifying that all the parts are included and check the nameplate
to be sure the voltage matches available utility power.
The line side of the disconnect switch contains live high-voltage.
The only way to ensure that there is NO voltage inside the unit
is to install and open a remote disconnect switch and verify that
power is off with a volt meter. Refer to unit electrical schematic.
Follow all local codes.
RISK OF ELECTRIC SHOCK OR EQUIPMENT DAMAGE
Whenever electrical wiring is connected, disconnected or
changed, the power supply to the ERV and its controls must
be disconnected. Lock and tag the disconnect switch or circuit
breaker to prevent accidental reconnection of electric power.
RISK OF CONTACT WITH HIGH SPEED MOVING PARTS.
Disconnect all local and remote power supplies, verify with
a voltmeter that electric power is off and all fan blades have
stopped rotating before working on the unit.
Do not operate this unit with any cabinet panels removed or
prior to assembly of the modules
RISK OF DAMAGE TO ENTHALPIC CORES
Whenever working within the ERV cabinet, protect the enthalpic
cores from accidental damage. The core media is subject to
damage from dropped tools or other foreign objects.
RISK OF CONTACT WITH HOT SURFACES
The blower motor and other electrical components are extremely
hot during operation. Allow sufficient time for them to cool
before working within the unit cabinet. Use extreme caution and
wear protective gloves and arm protection when working on or
near hot blower motors and electrical components.
This unit is intended for general ventilating only. Do not use to
exhaust hazardous or explosive materials and vapors. Do not
connect this equipment to range hoods, fume hoods or collection
systems for toxics.
This unit is for ventilating finished structures only. It is not to
be used until after all construction has been completed and
construction debris and dust are cleaned from the Occupied
Space.
This equipment is to be installed by following Industry Best
Practices and all applicable codes. Any damage to components,
assemblies, subassemblies or the cabinet which is caused by
improper installation practices will void the warranty.
NOTICE
NOTICE
NOTICE
CAUTION
CAUTION
CAUTION
CAUTION
