RZ/V2M Linux Package Start-Up Guide
R01US0527EJ0110 Rev.1.10
Page 21 of 39
Oct.8.2021
(2)
Case of eMMC Writes Failed
The following error messages are written in the log file when writing loader binaries to the eMMC fail. Check
the log file and the error contents if this process fails.
Note: Depending on the type of error, writing back from the backup area may be performed. They are shown as
Rewriting: Yes in Table 4-2 if you should rewrite.
Table 4-2. Error messages for eMMC write script
No.
Error message
Error content
Rewriting
1
Insufficient write file
Unable to confirm boot loader files in the SD card.
This error causes in the following cases:
⎯
A loader binary file is not written to the SD
card.
⎯
A partition of the SD card is not formatted
correctly.
⎯
SD card not inserted.
Recheck to see if binary files are stored in the
proper partition of the SD card.
No
2
Failed to load loader_1st_128kb.bin from SD
The size of a loader binary file in the SD card is
invalid.
Write the appropriate version of the loader binary
file to the SD card.
No
3
Failed to load loader_2nd_param.bin from SD
No
4
Failed to load loader_2nd.bin from SD
No
5
Failed to load u-boot_param.bin from SD
No
6
Failed to load u-boot.bin from SD
No
7
loader_1st_128kb.bin is CRC error
The CRC value of the file is different.
Write the appropriate Linux package version file to
the SD card.
No
8
loader_2nd_param.bin is CRC error
No
9
loader_2nd.bin is CRC error
No
10
uboot_param.bin is CRC error
No
11
u-boot.bin is CRC error
No
12
switch to partitions 1 error
Failed to switch the partition in eMMC. Check
whether the eMMC board is connected to RZ/V2M
Evaluation Kit.
No
13
MMC read error
Failed to data load from eMMC. Check whether
the eMMC board is connected to RZ/V2M
Evaluation Kit.
Yes
14
MMC erase error
Failed to erase data in eMMC. Check whether the
eMMC board is connected to RZ/V2M Evaluation
Kit.
Yes
15
MMC Write error
Failed to write to eMMC. Check whether the
eMMC board is connected to RZ/V2M Evaluation
Kit.
Yes
16
1st loader compare error
A file is not written to eMMC correctly.
Run the “rdk_shutdown” command, power on the
board again, and retry the eMMC writer macro.
Yes
17
2nd loader param compare error
Yes
18
2nd loader compare error
Yes
19
U-boot param compare error
Yes
20
U-boot loader compare error
Yes
