Renesas RZ/N1S-DB, Быстрый старт

Страница: 4 / 9

The following switches must be set.
Switch bank SW5
Number SW ON (low) SW OFF (high)
Default
Setting
1 RMII/MII LCD OFF
2 CAT/S3 PMOD ON
3 MSEBI Mixed OFF
4 RMII2 / MDIO3 QSPI2-Memory OFF
5 USB 1x Host 1x Device USB 2 x Host ON
6 ARM Debug FTDI Debug ON
7 Segger Debugger I-Jet Debugger OFF
8 Not used Not used OFF
Other switches
Switch SW ON (white bar) SW OFF
Default
Setting
SW3 JTAG Mode ARM Coresight Mode OFF
SW10 Boot from NAND Boot from QSPI OFF
SW11 LCD pull up LCD pull down ON
SW12 LCD pull up LCD pull down ON
SW1 RXCLK4 from PHY RXCLK4 from GPIO61 ON
SW7 RXCLK5 from PHY RXCLK5 from GPIO61 ON
Extension Board
The relevant switches of the Extension Board are shown below.
CN15, CN16
PHY2/3 MDIO
CN17, CN18
PHY1 MDIO
J18
I2C
J24
PHY3
(RGMII3) J23
PHY2
(RGMII2) J22
PHY1
(RGMII1)
CN14
5V or 12..24V