R0E5562GAPFK10 User's
Manual
R20UT2114EJ0100 Rev.1.00
Page 3 of 8
Sep 05, 2012
3. Specifications
Table 2 shows the functional specifications of this product.
Table 2 Specifications of this product
Item Specification
MCU for use
•
RX62T and RX62G groups MCUs in PLQP0064KB-A packages
The MCU type name
installed on this product
•
R5F562GABDFH (exclusive for debugging)
(ROM: 256 Kbytes, RAM: 16 Kbytes, Data flash: 32 Kbytes )
Power supply
•
Power(VCC) at 2.7
*1
to 3.6 V, or 4.0 to 5.5 V is supplied from the user system.
•
Power(AVCC0 = AVCC) at 3.0 to 3.6 V, or 4.0 to 5.5 V is supplied from the user
system.
•
The state of power supply can be monitored through the test pins (TP1 for VCC
and TP2 for GND).
•
The state of analog power supply can be monitored through the test pins (TP3 for
AVCC0, TP4 for VREFH0, TP5 for AVCC, and TP6 for VREF).
System clock (EXTAL)
•
This clock signal at 8 to 12.5 MHz is supplied from the user system.
Notes*:1. Please use it by voltage (VCC > V
POR
) that doesn't enter the state of power on reset.
4. Reset
Circuit
Figure 2 shows the reset circuit, with the level on the RES# pin pulled up by a 510-k
Ω
resistor.
38-pin connector (CN1)
Pin 9
(RES#)*
1
MCU
（
IC1
）
RES#
YQSOCEKT064SDF (CN2)
Pin 6
(RES#)*
2
R14
0
Ω
UVCC
R17
510 k
Ω
Notes* : 1. Indicated pin numbers are for pins of the 38-pin connector (CN1).
2. Indicated pin numbers are for pins of the YQSOCKET064SDF (CN2).
Figure 2 Reset Circuit
