User's
Manual
R20UT2114EJ0100 Rev.1.00
Page 1 of 8
Sep 05, 2012
R0E5562GAPFK10
Debugging MCU Board for 64-pin 0.5mm-pitch LQFP
of the RX62T and RX62G Groups
1. Overview
The debugging MCU board R0E5562GAPFK10 (hereafter referred to as “this product”) is for MCUs of the RX62T and
RX62G groups in the PLQP0064KB-A package.
With the E20 emulator, the emulator occupies some user port pins for controlling the emulator and output of trace
information. These user port pins must be connected with a 38-pin connector installed on the user system.
With this product, however, all user port pins are available for the user system. In addition, you do not need to install a
38-pin connector on the user system.
Figure 1 shows the configuration of a system that includes this product and an E20.
Be sure to read section 7, Notes on Usage, before using this product.
Figure 1 System Configuration
2. Components of this Product
Table 1 lists the components of this product. Check that you have all of the components when you unpack the box.
Table 1 Components of this Product
Component Quantity
Remarks
Debugging MCU board
(R0E5562GAPFK10)
1
For the dimensions of the board, refer to section 6,
Dimensions of this product.
YQPACK064SD
(from Tokyo Eletech Corporation)
1
Connector to be placed between this product and the
NQPACK.
NQPACK064SD-ND
(from Tokyo Eletech Corporation)
1
IC socket for mounting on the user system
YQ-GUIDE-S1
(from Tokyo Eletech Corporation)
4
Screws for fastening the YQPACK to the NQPACK.
Cautions in handling
1
Cautions when handling the products of Tokyo Eletech
Corporation
User’s Manual (English and Japanese)
1 for each
This manual (English)
Note: NQPACK, YQPACK, YQSOCKET, YQ-GUIDE, HQPACK, TQPACK, TQSOCKET, CSSOCKET,
CSPLUG/W, and LSPACK are trademarks of Tokyo Eletech Corporation.
R20UT2114EJ0100
Rev.1.00
Sep 05, 2012
