25.
Click OK to dismiss the Project Generator Information dialog.
26.
Select [Debug->Connect]
27.
To reprogram the LowPowerDemo into the flash, select “Writing the on-chip flash memory mode” to program
the device (recommended for current measurement) or “Debugging mode” to debug.
28.
On the Startup and Communication Tab, select:
Mode Pin Settings: Single-chip Mode
Register Setting:
Single-chip Mode
Endian:
Little
Endian
FINE Baud Rate:
750000 bps
29.
Click <OK>.
30.
The debugger will now try to connect. If the connection fails here, check that the jumper settings are correct
and that the power LED is lit.
31.
Dismiss the Configuration Properties dialog using the OK button
Содержание Promotional board
Страница 7: ......
