Renesas M30290T2-CPE, Руководство пользователя

Страница: 26 / 86

M30290T2-CPE User’s Manual 2. Setup
REJ10J0494-0200 Rev.2.00 July 16, 2005 Page 26 of 86
2.6.5 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected.
After turning on the power, only the LED5 (RESET) lights on. Check the target status LEDs
display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to “5. Troubleshooting” (page 78).
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
POWER
RESET
CLOCK
RUN
LED 3
LED5
LED4
LED6
: ON
: OFF
When the user system NOT connected:
The POWER LED does not light.
MADE
POWER
SW1
COMPACT EMULATOR
INT
JP1
5.
0V
JP2
3.
3V
EXT
CLOCK
RESET
RUN
LED3
LED6
L
E
D5
LED4
POWER
LED1
SAFE
LED2
J1
J2
Target status LEDs
System status LEDs
M30290 T2-CPE
POWER USB
5.0V
5.0V
3.3V
MCU
PO
WE
R
EXT
INT
JP2
JP1
STATUS
SYSTEM
STATUS
TARGET
MADE IN JAPAN
COMPACT EMULATOR
POWER
SAFE
POWER
CLOCK
RESET
RUN