FUSE
The inserted fuse protects the device from electrical shorts and capacity overload. If you need to replace the factory-provided fuse observe
by any means to keep the same fuse rating (7.5 A).
1
2
3
BEFORE THE CONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Ensure asufficient profile section
(at least 10 mm
2
), a suitable fuse rating and a high conductivity of the cables when you purchase your wiring kit. Clean and remove rust-streaked
and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the installation,
because loosely connections may cause malfunctions, unsufficient power supply or interferences. We recommend therefore the
RENEGADE
REN10KIT
wirekit.
BATT+12V
Connect the BATT+12V-terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a sufficient cross section (min. 10
mm
2
) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery must be shorter than
30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.
REM (TURN-ON SIGNAL)
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote wire of your head unit with the REM-terminal of the sound
system. Use a suitable cable with a sufficient cross section (0,5 mm
2
). Thereby the sound system will turn on or off automatically with
your head unit. If your head unit is not equipped with a remote wire check page 4, section #7.
4
GND
Connect this GROUND terminal with a suitable contact ground point on the vehicle’s chassis. The ground wire must be as short as possible
and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground point has a stable and safe electric
connection to the negative “–”pole of the battery. Check this ground wire from the battery to the ground point if possible and enforce it, if
required. Use a ground wire with a sufficient cross section (at least 10 mm
2
) and the same size like the plus (+12V) power supply wire.
ELECTRICAL INTERCONNECTION
ENG
1
2
3
4
Installation of RCA/Audio signal cables and power supply.
Attend while installation not to lead the audio cables between the headunit and the sound system together with
the power supply wires on the same side of the vehicle. The best is a areal separated installation in the left and
right cable channel of the vehicle. Therewith a overlap of interferences on the audio signal will be avoided. This
stands also for the equipped bass-remote wire, which should be installed not together with the power supply
wires, but rather with the audio signal cables.
REFERENCE NOTE
8
