Renegade ren 1100s mk3, Руководство пользователя

Страница: 11 / 32

11
FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Highpass filter controller REAR
(2) Selector FULL / LP (Lowpass) / HP (Highpass)
(3) Lowpass filter controller REAR
(4) Selector for the stage-to-stage enhancement of the bass level REAR
(5) Gain level controller REAR
(6) Audio signal inputs REAR
(7) Audio signal outputs to run additional amplifiers
(8) Audio signal inputs FRONT
(9) Gain level controller FRONT
(10) Selector FULL / HP (Highpass) FRONT
(11) Highpass filter controller FRONT
(12) PROTECT-LED and POWER-LED
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle’s battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the headunit or the electrical antenna
(7) Fuse(s)
4-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 4 line output channels* from the headunit to drive 4 loudspeakers, in
stereo connect the following setup:
(1) To the headunit, line output left REAR
(2) To the headunit, line output right REAR
(3) To the headunit, line output left FRONT
(4) To the headunit, line output right FRONT
(5) Loudspeaker left REAR
(6) Loudspeaker right REAR
(7) Loudspeaker left FRONT
(8) Loudspeaker right FRONT
3-CHANNEL OPERATION STEREO & MONO (FIG. 4)
If you want to run the amplifier with the 4 line output channels* the headunit to drive a pair of loudspeakers and
a subwoofer, connect the following setup:
(1) To the headunit, line output left REAR or subwoofer output
(2) To the headunit, line output right REAR or subwoofer output
(3) To the headunit, line output rear left FRONT
(4) To the headunit, line output rear right FRONT
(5) Loudspeaker left FRONT
(6) Loudspeaker right FRONT
(7) Subwoofer
* If your headunit only have 2 output channels, use commercially available Y-adapters for splitting the signal.
But then the FADER function of the headunit does not work anymore.
IMPORTANT!
Always observe the correct polarity of all connections!