Renault CLIO 2019, Руководство пользователя транспортного средства

Страница: 153 / 386

driving ...................................................(up to the end of the DU)
electronic parking brake .......................(up to the end of the DU)
brake.....................................................(up to the end of the DU)
instrument panel ....................................................(current page)
indicators:
instrument panel ..............................................(current page)
parking brake .........................................................(current page)
Stop & Start function..............................................(current page)
Stop & Start ...........................................................(current page)
2.21
ENG_UD58857_2
Autohold (XJA - Renault)
conditions for interrupting the
braking force
The following conditions must be met:
– the driver accelerates sufficiently
with a gear engaged;
or
– the driver disables the function.
Warning light

goes out on the in-
strument panel.
“AUTOHOLD” function
“aUToholD" fUncTion
Vehicle stopped (e.g. at a red light, an
intersection, a traffic jam, etc.), the func-
tion ensures braking force even when
the driver releases the brake pedal.
The braking force is released as soon
as the driver accelerates sufficiently
with a gear engaged.
activation
Press the switch 3 .
The switch warning light 3 illuminates
to confirm that the function is activated.
Deactivation
Press the brake pedal and 3 switch si-
multaneously.
The switch warning light 3 turns off,
confirming that the function is deacti-
vated.
If the braking force is maintained, the
parking brake is applied automatically
when:
– the driver exits the vehicle;
or
– the vehicle is immobilised for more
than approximately three minutes.
Before leaving the vehicle,
check that the electronic
parking brake is fully ap-
plied. Warning light
1
on
switch 2 and warning light
}
on
the instrument panel illuminate to
show that the parking brake is ap-
plied but switch off when the doors
are locked.
3
1
conditions for maintaining the
braking force
The following conditions must be met:
– the seat belt for the driver is fas-
tened;
and
– the electronic parking brake is re-
leased;
and
– the vehicle is not stationary on a very
steep slope.
The maintained braking force is con-
firmed by the

warning light on
the instrument panel.
Upon each start-up, the function
continues the mode set at the time
the engine was last switched off.
2