background image

3.3 

GENERAL OPERATION 

Coded Card 

The coded card system was introduced for the latest Laguna models and eliminates the 
use of 'ignition keys' and, optionally, 'door locking keys'. Instead of a key the driver has a 
coded card that, optionally, unlocks the door and after insertion into a card reader, sets 
self-retaining relays to supply the various systems/circuit in the vehicle (equivalent to the 
ignition switch), deactivates the immobiliser to allow the vehicle to be started and unlocks 
the electric steering lock. The code is a random rolling code to reduce the chances of 
simulation. 

The engine is started via an engine start/stop push switch, which when pushed will ener-
gize the starter. If pressed again the switch will stop the engine and removing the card 
will break the retaining circuit to the main relay and the vehicle will shut down all systems 
and circuits except any required to remain on, e.g. lighting circuits, hazard lights etc. The 
following are the immobilizer functions: 

• 

 Decodes the signal from the card via the card reader 

• 

Sends a signal to the electric steering column lock 

• 

Communicates with the EMS-ECM 

• 

Controls the immobilizer LED and the card reader light 

• 

Communicates with the immobilizer 

This system uses a multiplexing system to send data to peripheral devices, namely the 
electric steering lock, diagnostic socket, EMS-ECM and the LED in the instrument pack. 

All Systems 

Each system has a visual indication of the immobilizer status but whether or not it has a 
separate red LED to that of the EMS-ECM is dependent upon the system. If it shares and 
LED with the EMS-ECM this will flash regularly when the immobilizer is active and is also 
used to indicate acceptance of the security code numbers manually entered using the 
door locking button. In general the following functions are indicated by the LED: 

• 

 Activation of the immobilizer 

• 

Non recognition of the Coded Card or Coded Keys 

• 

System fault 

• 

Fault with the EMS-ECM immobilizer function 

• 

Fault with the Electric Steering Lock (Coded Card only) 

• 

Signal of entry into door locking remote control resynchronization mode (Decoder/
Multi Timer systems only) 

• 

If a fault with the EMS-ECM immobilizer circuit occurs whilst the vehicle is in motion 
the immobilizer LED will flash during deceleration and when at idle speed. 

 

Содержание 1992 ANTI THEFT SYSTEM R21













Отзывы: