Programming your remote
Handheld Remote – Single Channel
2.1
First, connect the Glide-Aside Track motor to
your power supply and turn on at the mains. The
motor will beep quickly 5 times to confirm it is on.
2.2
Press
CLOSE
(UP) key on your Remote –
the motor on the track should start – if there is no
response go to step
2.8
to reconnect your remote
and start again once it is connected and working.
2.3
The curtains will run to the end position
on the rail and the motor will automatically stop.
The Close Limit is now set.
2.4
Now Press
OPEN
(DOWN) on your Remote.
NOTE: You can also draw the curtain by hand –
the tug motion will automatically start the motor.
2.5
The curtains will run to the beginning position
on the rail and the motor will automatically stop.
The Open Limit is now set.
2.6
Now the limit settings are set you can use the
Open/Close buttons to move to the automatically
set limits – you can stop the motor to have the
curtains partly open with the
STOP
key at any time.
To Reset Open & Close Limits
2.7
Using a paperclip/small screwdriver press and
hold the
RESET
button on the base of the motor.
To Reconnect your Remote
2.8
Using a paperclip or small screwdriver, press
and hold in the
SETTING
button on the base
of the motor for 3 seconds until the motor beeps,
then release. Discovery Mode is now activated.
2.9
Now press the
CONFIRM
button with a
paperclip on the back of your Handheld Remote.
The motor will beep 4 times to confirm pairing.
Back of Handheld Remote Control
Press & hold for
3 seconds
then release
The motor will make
long beeps with a gap
This means discovery
mode is
activated
*
Continue to
Press & Hold for
7 seconds
Motor will beep quickly
8 times then go silent
All limit settings have
now been DELETED.
OPEN
CLOSE
STOP
Glide-Aside
can also
start
with a tug of
the curtain
NOTE:
You should set the OPEN & CLOSE LIMITS when connecting to power for the first time.
Ensure the remote LED lights up when a button is pressed – if not then your battery may be flat!
* Discovery Mode remains active and motor will continue to beep for 25 seconds ONLY. If you run out of time, simply repeat the process again.
CONFIRM
BUTTON
LIMIT
RESET
C L
DOWN
UP
STOP
LED
ANT
ON OFF
Setting
Reset
Base of
the Motor
REN073-2020NEW-06_v1
Tel
0113 250 4499
• Visit
rca-uk.com
