– 2 –
PREPARING THE
#EVO-
THESE INSTRUCTIONS REFER TO THE
RCS # EVO-
2.4 GHz 5 CHANNEL R/C.
N.B. CAB “A” and CAB “B” both have the standard 90° (100%) servo throw.
1. “BINDING”.
The 1st procedure is to “BIND” the receivers (Rx’s) to the Transmitter (TX).
When binding two Rx’s to the one Tx handpiece we recommend doing so one at a time.
“BINDING” is accomplished by following a few simple steps below.
KEEP THE TX HANDPIECE AT LEAST TWO METRES FROM THE LOCO.
HOW TO “BIND” USING A DSM2 RX.
1.1a
AUTO-BIND
receivers. Turn on the loco power >RX and wait 20 seconds for the RX to enter bind mode. RX LED
will flash rapidly OR;
1.1b MANUAL BIND
. Insert the “BINDING” plug supplied with the DSM2 RX into the “BINDING” pins on the
RX
.
You can also use the # BINDER switch assembly if you do not wish to get inside the loco.
1.2b MANUAL BIND
Turn the loco RX ON. The RX LED will be blinking very rapidly to indicate it is ready to be bound.
ON
– OFF SWITCH
FUNCTIONS OF # EVO-DUO-&-DUO+.
BUTTONS TO HOLD DURING BINDING.
1.3
Press
and hold
the right pushbutton on the handpiece marked with a hexagonal symbol. You should keep TX &
RX at least 1 x metre apart for binding to take place.
1.4
Then press
and hold
the ON
– OFF button to
ON
. Hold both buttons until the RX LED stops flickering & starts
blinking slowly. Then let both TX buttons go.
1.5
The LED on The TX button will blink slowly & then go to solid ON.
1.6
When “BINDING” is complete the RX LED will change to solid ON.
N.B.
“BINDING” plug
MUST
be removed
BEFORE
the SYSTEM is turned OFF.
1.7b
The “BINDING” plug is removed & stored safely.
RCS offers an optional extra
# BINDER
cable and pushbutton. When fitted, this will enable any loco with a manual bind
Rx to be bound to any TX without requiring access to the inside of the loco. This will enable any loco to be swapped
between any other DSM2 TX’s. You will be able to “hand off” speed matched locos for MU’ing into a consist.
TROUBLESHOOTING.
The # EVO- volt battery will eventually go flat if left switched on.
If the battery goes flat slowly the internal # EVO-operating program will likely be disrupted.
The Ch # 1 centering on the # EVO- system centering will need to be reset;
1.) Centre both control knobs.
2.) Turn the # EVO- ON. # EVO- ON
– OFF light will come ON.
3.) Within 60 seconds, press and hold the Ch # 5 bind button for 20 seconds.
4.) The # EVO- ON - OFF light will go off.
5.) Release bind button. LED will come on again. Centre reset is complete.
