- 3
–
4. USING THE EVO-BATT
WITH A “CENTRE OFF” ESC.
The EVO-BATT is ideal for use with RCS
CENTRE OFF
ESC’s such as the # VIPER-10-15 & # VIPER-10-24.
The VIPER ESC plugs into Ch # 1.
Before you switch the system on, make sure the throttle knob is in neu
tral. i.e. at the centre “click”.
You can bind as many locos as you wish to the EVO-BATT. The system was designed for controlling one loco at a
time.
CENTRE OFF CONTROL.
Turn the Tx handpiece on first. Then the loco.
FORWARDS -
SPEEDING UP.
To select forwards direction, twist the knob from neutral slowly clockwise (CW) to the right.
SLOWING DOWN
. Turn the knob back to the left (CCW) to set desired speed.
STOPPING
.
Completely stop the loco by bringing the knob back to neutral.
REVERSE -
SPEEDING UP.
To select reverse direction, twist the knob slowly to the left (CCW).
SLOWING DOWN
. Turn the knob back to the right (CW) to set desired speed.
STOPPING.
Completely stop the loco by bringing the knob back to neutral.
SHUTTING DOWN.
When you have finished operating, turn off the loco(s) before the TX.
Turn the loco OFF first. Then the # EVO-BATT
NEUTRAL OFF POSITION OF THE
EVO-BATT
SET THE FORWARDS DIRECTION &
SPEED CONTROL.
SET THE REVERSE DIRECTION &
SPEED CONTROL.
SOUND.
There are two function buttons on the lower RH side. They are using Channel # 3. These require an R/C switch such
as
# MRW-RDS
or
# MRW-SSDS
to operate sound triggers.
Plug the R/C switch into Ch # 3 on the Rx. The signal wire is Orange or White.
The Ch # 5 BIND button allows one other trigger via another
# MRW-RSS
or
# MRW-SSDS.
LIGHTING.
If your ESC does not have directional lights, RCS has a small add on module
# REV-LT
that responds to output voltage
and activates both Front & Rear lights accordingly.
TROUBLESHOOTING.
The EVO-BATT battery will eventually go flat if left switched on. The EVO-BATT operating program may be
disrupted.
The Ch # 1 centering on the EVO-BATT system will need to be reset;
1.) Centre the Ch # 1 knob.
2.) Turn the EVO-BATT ON. EVO-BATT ON
– OFF light will come ON.
3.) Within 60 seconds, press and hold the bind button for 20 seconds.
4.) The EVO-BATT ON - OFF light will go off.
5.) Release Bind button.
Light will come back ON. Centre reset is complete.
Содержание EVO-BATT
Страница 4: ......
