If you anticipate using regular twin stick
NiCd or NiMh battery packs with Tamiya
type connectors on each pack you can also
purchase the # Y-CABLE which will put 2 x
Twin Stick battery packs in series.
INSTALLATION.
1.
Place the BIK-TC2 in any suitable
location such as a box car door. You can
mount with double stick tape or a good
quality silicone adhesive. Do not allow
metal objects to touch the rear of the PCB.
Damage to PCB may result.
2.
Follow the wiring diagram carefully.
As various brands of locos are wired
differently we cannot offer “One Size Fits
All” instructions. It is essential the loco
track pick ups be disabled otherwise throttle
output voltage will be transferred to the
track & cause all sorts of problems.
The antenna wire should be kept as high as
possible.
Y-Cable is sold
separately.
Black
FUSES
Two orange polyswitches
means a 2 amp version.
Three orange polyswitches
means a 3 amp version.
Black
Black
Red
Red
Red
7.2 volt NI-CAD
BATTERY IN TRAIL CAR
PLUGS INTO THE BACK OF LOCO. ON-OFF SWITCH MUST BE ON.
7.2 volt NI-CAD
BATTERY IN TRAIL CAR
RCS # BIK-TC2.
DIY INSTALLATION KIT FOR TRAIL CARS
Use this battery installation kit with any R/C.
It comes rated at 2 or 3 amps.
It comprises the following components:
1 x PCB with ON-OFF switch, charge jack,
polyswitch fuses, screw terminals and an
LED power ON indicator.
Chg
Skt
OFF - ON
R
C
S
2.4 Ghz
RADIO
CONTROL
Plug cover
Radio Shack #274-1573
PO BOX 578 CASINO, NSW 2470, AUSTRALIA
PHONE: INTERNA+614 2902 9083
AUSTRALIA (04) 2902 9083
(03) 8685 8230
Web: http://www.rcs-rc.com Email: [email protected]
USING AS AN AUXILIARY BATTERY SUPPLY ONLY TO LOCO.
Positive goes to the centre pin
