"Dehumidification" mode
Make sure that the indoor unit is connected to the
power supply, and is switched on.
The operating mode indicator on the display of the
indoor unit begins to flash.
1.
Press the
"MODE"
key [1] to select "Dehu-
midification" mode.
2.
The temperature setting on the remote con-
trol has no effect on unit operation.
3.
Press the
"ON/OFF"
key [2] to switch on the
air conditioning unit.
1
2
Fig. 11: "Dehumidification" mode
In the “Dehumidification” mode, manual selec-
tion of the fan speed is not possible! Please
note that temperature pre-selection is not pos-
sible and the dehumidified room can cool dra-
matically!
"Timer" mode
Press the "TIMER" key to set the "switch-on time"
and the "switch-off time" for the unit.
Setting the “switch-on time”
The air conditioning unit has two different timer
modes:
Timer ON determines the time after which the unit
automatically switches itself on.
Timer OFF determines the time after which the unit
automatically switches itself off.
Activate the “Timer on” function by pressing the
Timer key [1]. The Timer ON symbol now appears
on the display. Select the required switch-on time
using the "+” and “-” keys [2]. The function acti-
vates itself after 3 seconds.
The target temperature and the Timer ON symbol
now appear on the display again as confirmation of
the function.
Activate the “Timer OFF” function by pressing the
Timer key [1] twice. The "Timer OFF" symbol now
appears on the display. Select the required switch-
off time using the "+” and “-” keys [2]. The function
activates itself after 3 seconds.
The temperature and the Timer ON symbol now
appear on the display again as confirmation of the
function.
Both functions can also be used together. For
example, if the unit is to switch on in 6 hours and
switch off two hours later, proceed as follows:
Press the Timer key [1] and ensure that the Timer
ON symbol illuminates. Press the “+/-” keys [2]
until “6.0h” appears on the display. Now press the
Timer key [1] again. The Timer OFF symbol should
appear on the display. Use the “+/-” keys [2] to set
the time to 8.0h and then wait for 3 seconds for the
functions to activate themselves automatically.
Times which have already been set can be
changed. To do this, select either Timer ON or
Timer OFF mode and change the time using the
“+/-” keys [2]. Please note that this delay is then
activated from the current point in time, not the
point in time when the original programming took
place!
Delays which have already been programmed can
be deactivated by reducing the time to 0.0h in the
respective menu (Timer ON or Timer OFF).
Note: When the switch-on and switch-off times are
being set, this can be done at 30 minute intervals
for the first 10 hours, and at hourly intervals there-
after. The maximum switch-on or switch-off delay is
24 hours.
REMKO RVT series
24
