4.3 Keys on the remote control
11
9
10
12
13
2
1
4
5
3
6
7
8
14
Fig. 7: Keys on the remote control
1
"ON/OFF" key
Press this key to switch the air conditioning unit on
and off.
2
Operating mode selection
This key is used to set the desired operating mode.
The automatic, cooling, dehumidification, heating
and recirculation modes are available.
3
Eco key (sleep mode)
Pressing once activates ECO mode (only available
in cooling mode). As well as the temperature, “eco”
is now shown on the display. If the target tempera-
ture is set to less than 24 °C, in ECO mode the
temperature is automatically increased to 24 °C
and the fan changes the mode to automatic. If the
target temperature is greater than 24 °C, the set
temperature is retained and the fan speed regu-
lates itself downwards. If you press the ECO key
again, change the function mode or reduce the
target temperature to less than 24 °C, ECO mode
is exited. Press and hold the key for 2 seconds to
activate sleep mode.
During sleep mode, the target temperature
increases automatically by 1 °C within an hour in
cooling mode, and decreases automatically by 1
°C within an hour in heating mode. Press this key
to maintain the most convenient temperature and
save energy. This function is only available in
"Cooling", "Heating" and "Auto" modes. If the unit
is working in "SLEEP" mode, this activity is inter-
rupted by pressing the "MODE", "FAN", "Speed" or
"ON/OFF" keys.
4
“Timer” key
A switch-on delay and a switch-off delay of the unit
can be programmed with this key. Details of this
can be found in the section “Timer mode”
5
"LED" key
This activates/deactivates the display on the indoor
unit.
When the display is switched on again, it flashes
for 15 sec. and then the actual temperature is dis-
played. Then the target temperature appears on
the display and the flashing stops.
6
"FOLLOW ME" key
This key can be used to activate/deactivate the
FOLLOW ME function. In this mode, the room tem-
perature is measured on the remote control. This
sends a signal to the indoor unit every 3 minutes. If
the remote control does not send a signal to the
indoor unit for 7 minutes, this mode is automati-
cally deactivated.
7
"TURBO" key
Activation of the turbo function makes it possible to
reach the setpoint in cooling or heating mode as
fast as possible. Increase noise emission can be
expected.
REMKO RVT series
20
