REMKO JBW 260 DC AT, Руководство по сборке и эксплуатации

Страница: 18 / 52

Setting the "Auto off" time
1. Press the "TIMER OFF" key. The remote
control shows "TIMER OFF", the last "Auto
off" time setting and the symbol "H" appears
on the display. The unit is now ready to reset
the "Auto off" time and to stop "TIMER OFF"
mode.
2. Press the "TIMER OFF" key again to set the
desired "Auto off" time. Each time the key is
pressed, the time is increased by half an
hour between 0 and 10 hours, and by an
hour between 10 and 24 hours.
3. Once these settings have been made, there
is a one second delay before the remote con-
trol transmits the signal to the indoor unit.
Then, after approx. two seconds, the "H"
symbol disappears from the LCD display, and
the set temperature appears again on the
display.
– When Timer mode is selected, the remote
control automatically transfers the timer
signal to the indoor unit for the specified
period of time. Therefore, you should hold
the remote control in a location where it can
transfer the signal to the indoor unit without
interference.
– The effective operation for the time settings
by the remote control for the timer function
is restricted to the following settings:
0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0,
5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10,
11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21,
22, 23 and 24.
SLEEP function
In this function, the unit automatically increases (in
cooling mode) or reduces (in heat mode) the tem-
perature in the first two hours by 1°C an hour. For
the next five hours, the temperature is them kept
constant. Then this function is stopped.
The function maintains the most comfortable tem-
perature while saving energy.
8
Fig. 14: "Sleep" function
The "SLEEP" function is only available in the
"Cooling", "Heating" and "Auto" modes.
Adjusting the airflow direction
Use the "SWING" (up/down arrows) and "SWING"
(left/right arrows) keys to achieve the desired air-
flow direction.
1. Press the relevant "SWING" key to determine
the horizontal or vertical position of the
exhaust fins. Each time the "SWING" key is
pressed, the fins change position by 6
degrees.
2. You can activate the "SWING" function by
pressing the same key for longer. This
causes the exhaust fins to move up and
down automatically.
If the fins are moved to a position which would
influence the cooling or heating effect of the air
conditioning unit, they change their direction of
movement automatically.
REMKO JBW...DC
18