REMIfrontII-T
User information
Issue 39/2005
We reserve the right to make changes
Page 2/4
C.
Assembly information
We recommend that the blind system is installed by a specialist workshop !
No liability or warranty is accepted in cases of incorrect assembly or installation.
Step 1: (Check scope of delivery)
B1:
1 front system
Left and right
cassette
Top guide tube
Bottom guide tube
1 side system,
driver's side
1 side system,
passenger side
B2:
1 tube holder with
adhesive strip for
top guide tube
1tube holder for
bottom guide tube
4 caps
4 screws LK3.9x32
4 screws SK4.2x13
12 screws LIK3.5x16
1 plastic strip
Step 2: (Assemble guide tubes, for trade only!)
B3-B4:
If the top and
bottom guide tubes
are delivered
separately, they
must be joined with
the adhesive
supplied with the kit.
B5:
The adhesive is
applied into the
guide tube at the
end without the
thread. Use
sufficient to fill the
front part of the
opening generously.
B6:
The guide tube with pin is now pushed rapidly into the other tube. Allow the joined
tubes to harden for 10-15 minutes!
Important:
i)
Always link two of a pair!
ii)
The tubes should be laid on a flat surface and be aligned so that the
bends point in the same direction (see B3).
Step 3: (Mount front system)
B7:
Remove cover from
A pillar and if
necessary push
cables towards the
centre of the cab.
(This avoids screw
damage!)
B8:
Align cassette on the
left and right on the
A-pillar cover, so
that the screw lugs
lie firmly against the
rubber door seal.
B9:
The top lug must be
in line with the A-
pillar cover.
B10:
Bore holes into the
A-pillar vertically to
the cover surface at
the markings
(Ø2.5mm).
B11 & B12:
Screw the cassette
left and right onto
the 4 fixing points.
(Screws LK3.9x32)
B13:
Screw the carrier for
the bottom guide
tube to the middle of
the instrument panel
and screw on
directly in front of
the ventilation slits.
(Screws SK4.2x13)
B8
B9
B10
Accessories
B4
B6
B
B7
B11
Top guide tube
Bottom guide tube
Cassette Lefti
Kassette Right
B12
B3
B5