6
5
4
KEY PARTS
ABOUT YOUR SHAVER
R405AU SPECIFICATIONS
Power System
Corded
Voltage Type
Worldwide
Replacement Part No.
SP-4141AH
Power System:
Corded - Shaver can only be used with the power cord.
Voltage Type:
Worldwide Voltage – shaver automatically adapts to an outlet
voltage between 100V and 240V.
Note:
Some countries require the use of a plug adaptor that is not included with
your shaver
SHAVING
1. Slide power switch up to turn on. (Diagram D)
2. Shave face and neck using short, circular strokes. (Diagram E)
3. After shaving, turn the shaver off. (Diagram D)
D
E
**Remington recommends that you use your new shaver daily for
up to three weeks to allow time for your hair and skin to become
accustomed to the new shaving system**
SHAVING TIPS
•
Ensure your skin is dry and free of oils.
•
Wait at least 15 minutes after getting up before shaving, to ensure your face
is free of puffiness that may be present from sleeping.
•
Always hold the shaver at a right angle to the skin so that all three heads
are touching the skin with equal pressure.
•
Stretch skin with the free hand so hairs stand upright, making it easier for
them to enter the cutting chamber.
•
Use moderate to slow, circular stroking movement.
R405AU CLASSIC CONTROL MAINS SHAVER
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington® Classic Control Mains Shaver.
Inside this manual you will find tips on using and caring for your shaver.
•
The use of short, circular motions in stubborn areas may obtain a closer
shave, especially along the neck and chin line.
•
Do not press hard against the skin to avoid skin irritation and/or damage to
the rotary heads.
TRIM
1. Pull trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns. (Diagram G)
3. Close trimmer by pressing down. (Diagram H)
F
G
H
CLEANING & MAINTENANCE
Daily:
1. Press the hairpocket release button to open hairpocket assembly. (Diagram I)
2. Tap out excess hair shavings. (Diagram J)
3. Close hairpocket assembly. (Diagram K)
Monthly:
1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hairpocket assembly. (Diagram L) Place the
body of the shaver aside to ensure that it will not get wet.
3. Place a drop of liquid soap on each cutter. (Diagram M)
4. Brush the soap around vigorously using the supplied cleaning brush.
(Diagram N)
5. Release the inner cutter carrier by rotating the locking arms
counter-clockwise. (Diagram O)
6. Remove the inner cutter carrier away from the cutters. (Diagram P)
7. Remove the cutters. (Diagram Q)
8. Thoroughly brush any hair off of the inner and outer cutters (Diagram R) and
rinse away any soap and debris from inner and outer cutters. (Diagram S)
9. Replace the inner cutters. (Diagram T)
10. Place the inner cutter carrier back into position and lock into place by
rotating the locking arms clockwise until they snap into place. (Diagram U)
1. Head & cutter assembly
2. Individual flexing heads
3. Pop-up trimmer (rear)
4. Hairpocket release button
5. On/Off slide switch
6. Power port
Also includes:
Power adaptor
Cleaning brush
2
3
1
5
6
IMPORTANT SAFETY INSTRUCTIONS
When using an electric shaver, basic safety precautions
should always be observed, including the following.
Read all instructions before using this shaver.
KEEP POWER ADAPTOR AWAY FROM WATER
WARNING – TO REDUCE THE RISK OF BURNS, FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS:
•
The shaver should never be left unattended when
plugged into a power outlet, except when charging the
shaver.
•
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
•
Use this shaver only for its intended use as described in
this manual. Do not use attachments not recommended
by Remington.
•
Never operate this shaver if it has a damaged cord or
plug, if it is not working correctly, if it has been dropped
or damaged, or dropped into water. If the supply cord or
plug of this shaver is damaged it must be replaced. It
cannot be repaired.
•
Keep the cord away from heated surfaces.
•
Charge, use and store the product at a temperature
between 0°C and 32°C.
•
Never insert any object into any opening of this shaver.
•
Do not use outdoors or where aerosol (spray) products
are being used, or where oxygen is being administered.
•
Do not use the shaver with a damaged or broken tracks
or cutters, as injury may occur.
•
For use on facial hair only. Not intended for shaving the
hair on your head.
•
Do not plug or unplug the shaver with wet hands.
•
For household use only.
Remington strongly recommends that an approved
Safety Switch (residual current device) be installed to
protect all bathroom power outlets. Ask an electrical
contractor for advice.
SAVE THESE INSTRUCTIONS
3
2
4
