9
To assure smooth, efficient performance, it
is important to clean your shaver.
Daily
Brush inside the
head assembly after
each use:
1.
Turn the shaver off.
2.
Grip the head
assembly by the
three ridges and
pull it off the
shaver.
3.
Use the cleaning
brush to sweep
out the internal
part of the head
assembly and the
hair pocket area,
where 3 shaver
spindles are located.
4.
Replace head
assembly.
Weekly
Clean under the cutter assembly at least
once a week:
1.
Turn the shaver off.
2.
Open the head assembly as above.
3.
Unscrew the center screw knob to
remove the cutter retainer assembly.
4.
Use the cleaning brush to sweep the dust
and hairs from under the cutters.
5.
Replace head assembly.
Lubricate
Remington
®
Shaver Saver
®
Lubricant (SP-4)
lubricates and cleans your shaver's cutters
and head assembly. The lubricant helps
remove hair clippings while reducing wear.
A quick spray after each shave keeps your
shaver operating at peak performance.
Cleaning Cautions
■
The construction of this shaver is for
dry operation only. It is not water-
proof. Never put the shaver in part or
completely into water.
■
Never clean the shaver or replace the
cutters while it is plugged into an
electrical outlet.
■
Do not use an aggressive cleansing
agent as this may destroy the shaver
coatings.
■
Do not clean or remove the head assem-
bly while the shaver is running or plugged
in, as it may cause damage to the unit's
heads or cutters.
■
Replace worn or damaged parts with
Remington
®
replacement parts only.
8
When is it Time to Replace
Your Heads and Cutters?
It is very important to replace your
heads and cutters when necessary to
ensure a close, comfortable shave with-
out irritation. We recommend they be
replaced every 12 months. Here are
some signs of head and cutter wear,
indicating that replacement is needed.
Irritation
As the heads get excessively worn you may
experience some skin irritation. This would
be especially noticeable when you apply
after-shave lotion.
Pulling
When the cutters wear you may feel a
sense of pulling and a loss of closeness
when you shave. This is an indication that it
is time to replace your heads and cutters.
The replacement parts for your shaver is
model SP-16.
U.S. residents: To order, contact
us at 800-736-4648, visit us at
www.remington-products.com or visit
your local retailer.
Canadian residents: For any shaver
accessory requirements, please call
800-268-0425 or visit us at
www.remington-products.com
Head/frame
assembly
Floating
cutter
heads
Locating pins
Cutter retainer
assembly
Center
screw
knob
Locating holes
!
Important:
Make sure to align the two
locating holes in the Cutter Retainer
assembly with the pins in the Head Frame
Assembly. (See illustration below). Then
tighten center screw knob to lock the
cutters into place.
Replace head assembly on the shaver
simply by pushing it onto the shaver.
Cover shaver head with plastic headguard
between uses. When removing the head-
guard or placing it back onto the shaver,
do not apply pressure to floating cutter
surfaces, as you may damage them.
Cleaning and Maintenance
28879_R800_revised series 11/4/05 4:02 PM Page 8
