3. Hold the hair clipper in one hand so that the blades are at the top, and the front
of the hair clipper is facing you.
4. Place your thumb of the opposite hand underneath the blades at the front of the unit,
hold the back of the blade set with your fore finger and middle finger and firmly
press upwards with your thumb. The blade set will detach from the hair clipper.
5. Brush the accumulated hair from the hair pocket and blades.
6. Replace the blade set by inserting the notch (on the inside at the bottom of the
blade set) into the groove of the hair pocket and firmly push down with the palm of
your hand until you hear an audible ‘click’ and the blade set is locked into place.
STORAGE
When not in use, unplug the hair clipper and store it out of reach of children in a safe
dry place. Never wrap the cord around the hair clipper as this will cause the cord to
wear prematurely and break. Handle the cord carefully for long life and avoid jerking,
twisting or straining especially at the plug connections.
TROUBLESHOOTING
The hair clipper does not work when turned on:
Hair clipper must be charged for a full 16 hours, or use hair clipper while plugged into wall.
Hair clipper cutters do not move:
The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning &
Maintaining section.
Hair clipper does not hold charge:
Fully discharge the battery by running hair clipper until it stops; then follow recharging
instructions (see section on Charging Your Hair Clipper).
trimming just a little at a time.
STEP 2 - BACK AND SIDE OF THE HEAD
With the 9mm or 12mm setting in place, cut the hair at the back of the head.
STEP 3 - SIDE OF THE HEAD
a.
With the 9mm or 12mm setting in place, trim sideburns.
STEP 4 - TOP OF THE HEAD
a.
With the setting of your choice, cut the hair on top of the head against the
direction in which the hair normally grows.
b.
For longer hair on top, use scissors. Lift the hair on top of the head with styling
comb. Cut over the styling comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
c.
Always work from the back of the head.
STEP 5 - THE FINISHING TOUCHES
a.
Use the hair clipper without an attachment comb for close trimming around
the base and sides of the neck.
b.
To produce a clean straight line at the sideburns, reverse the hair clipper.
Place the reversed hair clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
CLEANING & MAINTENANCE
To ensure long lasting performance of your hair clipper, clean the blades and unit
regularly.
NOTE: Ensure that the hair clipper is turned off and unplugged
when cleaning.
AFTER EACH USE
1. Ensure the hair clipper is switched off and disconnected from the mains
household power outlet.
2. Brush the accumulated hair from the blades. Do not submerge the hair clipper in water.
3. To clean the body of the unit, wipe with a damp cloth and dry immediately.
4. Gently brush the remaining hairs away from the hair clipper comb and hair
clipper blade. Do not rinse the cutter assembly under water.
EVERY SIX MONTHS
At regular intervals the blade set should be removed and cleaned.
1. Ensure that the hair clipper is empty of power, is switched off and disconnected
from the mains household power outlet.
2. Remove the comb attachment.
2 YEAR
WARRANTY
HC8008AU
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
HAIRCUT KIT
9
8
7
10
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law
means the Australian consumer law set out in Schedule 2
to the Competition and Consumer Act 2010;
CGA
means the New Zealand Consumer Guarantees Act 1993;
Goods
means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We
or
us
means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier
means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You
means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty
subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period
of two (2) years from the date of purchase
(Warranty Period)
. If the Goods prove
defective within the Warranty Period by reason of improper workmanship or material,
we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable to
misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of
the user. As far as the law permits, the manufacturer does not accept liability for any
direct or consequential loss, damage or other expense caused by or arising out of any
failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Supplier, the date and place of purchase, the product name or other product serial
number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
industrial or commercial use of the Goods. The Goods must be connected to the electrical
voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the
Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, VIC 3194 Australia
Customer service in Australia: 1800 623 118
E-mail: [email protected]
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
Building C, Ground Floor
600 Great South Road,
Greenlane, Auckland 1051 New Zealand
Customer service in New Zealand: 0800 736 776
E-mail: [email protected]
Website: www.remington-products.com.au
REMINGTON SERVICE HOTLINE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trade Mark of Spectrum Brands, Inc. (SBI), or one of its subsidiaries
© 2012 SBI
Rev. 12/12
Part No. T22-0001116
This product is not suitable to use in a bath or shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
