6
www.remingtonpowertools.com
RECHARGEABLE BATTERY
The charger is designed to use standard house-
hold 120 volt 60 Hz power
1.
Plug cord from charger into charger base.
(See Figure 1)
2. Plug the charger into any standard 120
Volt 60 Hz electrical outlet. Important: Do
not charge by means of an engine genera-
tor or DC power source. Use only 120V
AC.
3.
Slide the charger onto the battery pack as
shown in Figure 2. The LED will light up,
Let the battery pack charge until red LED
turns off. After the initial charge, under
normal usage, your battery pack should be
fully charged in 3 to 9 hours.
4.
Unplug charger. Remove the battery pack
by sliding out (See Figure 3).
5.
Place the battery pack in the tool and be
certain that it is inserted fully into the tool
cavity until it “clicks” into place.
The battery pack is not fully
charged at the factory. Before
attempting to charge the battery
pack, thoroughly read all Safety
Instructions.
Figure 1 - Plug Charger into Base
Figure 3 - Remove Charger
PROTECTIVE BATTERY
TERMINAL CAP
A protective battery terminal cap is provided
for use whenever the battery is out of the tool
or charger. Remove cap before placing battery
in charger or tool.
b. An extension cord must have adequate
wire size (AWG or American Wire
Gauge) for safety, and to prevent loss of
power and overheating. The smaller the
gauge number of the wire, the greater
the capacity of the cable; that is, 16
gauge has more capacity than 18 gauge.
When using more than one extension to
make up the total length, be sure each
extension contains at least the minimum
wire size.
CHART FOR MINIMUM WIRE SIZE (AWG)
OF EXTENSION CORDS NAMEPLATE
RATING AMPS – 0 – 10.0
SAFETY WARNINGS
3. Do not expose charger to rain or snow.
4. Use of an attachment not recommended
or sold by Remington brand may result in
a risk of fi re, electric shock, or injury to
persons.
5.
To reduce risk of damage to electric plug
and cord, pull by plug rather than cord
when disconnecting charger.
6.
An extension cord should not be used un-
less absolutely necessary. Use of improper
extension cord could result in a risk of fi re,
electric shock or electrocution.
a. Two-wire cords can be used with 2-
wire or 3-wire extension cords. Only
round jacketed extension cords should
be used, and we recommend that they
be listed by Underwriters Laboratories
(U.L.). If the extension is to be used
outside, the cord must be suitable for
outdoor use. Any cord marked for
outdoor use can also be used for indoor
work. The letters “W” or “WA” on the
cord jacket indicate that the cord is suit-
able for outdoor use.
Cord
Length
AWG Cord
Size
25 feet
18 AWG
50 feet
18 AWG
100 feet
16 AWG
150 feet
14 AWG
7. Use only the supplied charger (P/N
121397-01)when charging. The use of any
other charger could damage the battery or
create a hazardous condition.
8.
Use only one charger when charging.
9.
Use only Remington RB18V1 or RBE18V1
battery packs with this product.
10. Do not attempt to open the charger. There
are no customer serviceable parts inside. If
damaged, call DESA Power Tools Techni-
cal Service.
11. DO NOT incinerate the battery pack even
if they are severely damaged or completely
worn out. The batteries can explode in a
fi re.
12. A small leakage of liquid from the battery
pack cells may occur under extreme usage,
charging, or temperature conditions. This
does not indicate a failure. However, if
the outer seal is broken and this leakage
gets on your skin:
• Wash quickly with soap and water.
• Neutralize with a mild acid such as
lemon juice or vinegar.
• If the battery liquid gets in your eyes,
fl ush them with clean water for a mini-
mum of 10 minutes and seek immediate
medical attention.
13. DO NOT open or mutilate the batteries.
Released electolyte is corrosive and may
cause damage to the eyes and skit. It may
be toxic if swallowed.
MEDICAL NOTE: The liquid is a
25-35% solution of potassium
hydroxide.
1. This manual contains important safety
and opertaing instructions.
2. Before using battery charger, read all
instructions and cautionary markings on
battery charger, battery pack, and product
using battery pack.
CHARGING BATTERY
Figure 2 - Sliding Charger onto Battery
To reduce the risk of injury,
charge only Remington brand
batteries. Other types of batter-
ies may burst causing personal
injury and damage.
CAUTION:
WARNING
Do not store or carry battery so that
metal objects can contact exposed
battery terminals. For example,
do not place battery in aprons,
pockets, tool boxes, product kit
boxes, drawers, etc. with loose
nails, screws, keys, jewelry etc.
without battery cap. The battery
or conductor may overheat and
case burns
