7
CLEANING, CARE & MAINTENANCE
NOTE:
Always clean the groomer attachments regularly to ensure maximum
performance and a proper operating life. Do not rinse the groomer with water.
Ensure to fully remove any attachments from the unit before rinsing these separately.
CLEANING ATTACHMENTS WITH WATER
1. Remove attachment.
2. Rinse ONLY the attachment under warm running water. Do NOT use hot water as
this might cause damage.
CLEANING ATTACHMENTS WITH THE BRUSH
• After first removing attachment, thoroughly brush and blow out hair clippings
from cutting system, attachment, and top of groomer handle.
CLEANING FOIL SHAVER ATTACHMENT
The foil shaver attachment has a release button at the back to remove it from the
groomer. To remove, press the button then slide off.
OILING BLADES & CAUTIONS
• Rinsing attachments under water (above) requires lubricating the cutting blades
1x monthly. Using only light-grade oils (e.g. sewing machine oil), simply spread
1-2 drops lightly over cutters with fingertip. Wipe away all excess.
• Use only light-grade oils as these will not evaporate nor slow down speed of
cutting blades.
• Do not use hair oil, grease, or any oil mixed with kerosene or solvent as these too
will evaporate.
TROUBLESHOOTING
Q: WHAT IF THE CUTTERS DON’T MOVE WHEN TURNED ON?
A:
The cutting unit may be dirty or clogged. Clean and lubricate the groomer as
described previously.
Q: WHAT IF THE GROOMER DOESN’T WORK AT ALL WHEN TURNED ON?
A:
The groomer might simply need charging. Follow instructions for charging as
described previously - refer to page 4. Should charging prove unsuccessful, contact
the REMINGTON SERVICE HOTLINE for assistance - refer to page 10.
Q: WHAT IF THE GROOMER FAILS TO HOLD A CHARGE?
A:
Fully discharge the groomer by running it until it completely stops. Next, follow
recharging instructions described previously. If time between recharging cycles
fails to increase, the battery might require replacement. Contact the REMINGTON
SERVICE HOTLINE for assistance - refer to page 10.
