REMEHA Quinta Pro 115, Инструкция по установке, эксплуатации и обслуживанию

Страница: 26 / 88

Type Principle Description
Permitted manufacturers
(1)
C
63(X)
This type of unit is supplied by the manufacturer
without a supply and discharge system.
When selecting the material,
please note the following:
Condensed water must flow
back to the appliance
The material must be resist­
ant to the flue gas tempera­
ture of this appliance.
Maximum permissible recir­
culation of 10%.
The air supply and the flue
gas outlet must not be placed
on opposite walls.
Minimum permitted pressure
difference between the air
supply and the flue gas outlet
is -200 Pa (including -100 Pa
wind pressure).
(1) The material must also satisfy the material property requirements from the relevant chapter.
6.5.2 Material
Use the string on the flue gas outlet material to check whether it is suitable
for use on this appliance.
1 EN 14471 of EN 1856–1: The material is CE approved according to
this standard. For plastic this is EN 14471, For aluminium and
stainless steel this is EN 1856-1.
2 T120: The material has temperature class T120. A higher number
is also allowed, but not lower.
3 P1: The material falls into pressure class P1. H1 is also allowed.
4 W: The material is suitable for draining condensation water
(W=’wet’). D is not allowed (D=’dry’).
5 E: The material falls into fire resistance class E. Class A to D are
also allowed, F is not allowed. Only applicable to plastic.
Warning
The coupling and connection methods may vary depending on
the manufacturer. It is not permitted to combine pipes, coupling
and connection methods from different manufacturers. This also
applies to roof feed-throughs and common channels.
The materials used must comply with the prevailing regulations
and standards.
Please contact us to discuss using flexible flue gas outlet mate­
rial.
Tab.13 Overview of material properties
Version Flue gas outlet Air supply
Material Material properties Material Material properties
Single-wall, rigid Plastic
(1)
Stainless steel
(2)
Thick-walled,
aluminium
(2)
With CE marking
Temperature class T120 or
higher
Condensate class W (wet)
Pressure class P1 or H1
Fire resistance class E or bet­
ter
(3)
Plastic
Stainless steel
Aluminium
With CE marking
Pressure class P1 or H1
Fire resistance class E or bet­
ter
(3)
(1) according to EN 14471
(2) according to EN 1856
(3) according to EN 13501-1
Fig.12 Sample string
AD-3001120-01
EN 14471 - T120 P1 W 1 O50 LI E U0
EN 1856-1 - T120 P1 W VxL40045 G(xx)
1 3 2 4 5
6 Installation
26 123157 - v.12 - 07022018