10
91792
MAINTENANCE
The following dispenser maintenance should be performed at the intervals indicated:
DAILY
(or as required)
Remove foreign material from the vending area sink to prevent drain blockage.
WEEKLY
(or as required)
Clean vending area. Check for proper water drainage from the vending area sink.
MONTHLY
Clean and sanitize the hopper interior (see CLEANING INSTRUCTIONS).
START-UP AND OPERATING INSTRUCTIONS
Fill the hopper with ice. With a built-in cold plate, dispense several large cups of ice (approximately 1 minute
total dispensing time) to allow ice to fill the cold plate. Add ice to the hopper as necessary to refill then replace
the lid. Allow 10 to 15 minutes for the cold plate to cool down. Repeat this procedure whenever the dispenser
has been standing overnight or other long periods without ice use. Start up the beverage system and adjust fau-
cets to the proper brix. Contact your local distributor for complete information on the beverage system.
In normal operation, pushing the ice dispenser lever will cause ice to flow from the ice chute. Ice flow will contin-
ue until the lever is released. Pushing the lever on any faucet will provide beverage of the appropriate flavor.
For automatic ice filling “K”models, the agitation timer causes the ice to level which allows the entire storage bin
to fill before the ice machine shuts off. The icemaker control capillary bulb maintains the ice level in the storage
hopper. Consult the instructions provided with the installation kit and the icemaker manual for location and op-
eration of the icemaker control.
CAUTION: Use caution to avoid spilling ice when filling dispenser. Immediately clean up
any ice spilled from filling or operating the unit. To prevent contamination of ice, the lid
must be installed on the unit at all times.
CLEANING INSTRUCTIONS
WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may attack the plastic
material.
DISPENSER
(all models)
1. Clean the ice storage hopper at least once a month.
Содержание DB200/275R
Страница 8: ...5 91792 FIGURE 3 BEVERAGE SYSTEM SCHEMATIC 8 VALVE HOOK UP...
Страница 9: ...6 91792 FIGURE 4 BEVERAGE SYSTEM SCHEMATICE 10 VALVE HOOK UP...
Страница 18: ...15 91792 FIGURE 9 WIRING DIAGRAM DB 275...
Страница 25: ...CORPORATE HEADQUARTERS Remcor Incorporated 500 Regency Drive Glendale Heights IL 60139 708 980 6900...
